1、AMSC N/A FSC 5920 METRIC A-A-59688/2C 4 May 2009 SUPERSEDING A-A-59688/2B October 28, 2004 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET FUSE, CARTRIDGE, INSTRUMENT TYPE, 5 MM X 20 MM, QUICK-ACTING, LOW-BREAKING CAPACITY The General Services Administration has authorized the use of this commercial
2、 item description for all federal agencies. The complete requirements for procuring the fuses described herein shall consist of this document and the issue in effect of A-A-59688. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item description (CID) specification sheet uses a cl
3、assification system which is included in the PIN as shown in the following example (see NOTES). AA59688/02 - 001 A CID number Dash number (see table I) Configuration (see figure 1) SALIENT CHARACTERISTICS. Interface and physical dimensions. Fuses supplied to this CID specification sheet shall be as
4、specified herein, and shall meet the requirements of ANSI/IEC 60127-2, part 2 (see figure 1). Case or body. The case or body shall be glass. Ferrules. The materials for the ferrules shall be nickel or silver plated brass. Mounting. Configuration A (ferrule type) is intended to be used with an applic
5、able fuseholder or fuse clip. Configuration B (axial leads) is intended to be directly soldered onto a printed wiring board. Current rating. The ampere rating shall be as specified in table I. Voltage rating. The voltage rating shall be 250 V ac maximum. Voltage drop. Voltage drop shall be in accord
6、ance with table I. Pre-arcing time/current characteristic. Pre-arcing time/current characteristic shall be as specified in table II. Breaking capacity. The breaking capacity shall be 35 amperes maximum or 10 In, whichever is greater. Endurance. Endurance shall be 100 cycles at 1.2 times the rated cu
7、rrent followed by 1 hour at 1.5 times the rated current. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/2C 2 mm Inches Ltr Min Max Min Max A 5.0 5.3 .20 .21 B 8.0 12.0 .31 .47 C 19.5 20.5 .77 .81 D 36.0 41.00 1.42 1.61 E 8.0 12.0 .31 .47 F
8、 19.7 21.7 .78 .85 G .62 .82 .02 .03 H 5.0 6.0 .20 .24 NOTES: 1. Dimensions are in millimeters. 2. Tolerance is 0.13 mm (.005 inch), unless otherwise specified. FIGURE 1. Interface and physical dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-
9、,-,-A-A-59688/2C 3 TABLE I. Characteristics. CID dash number AA59688/02- Configuration Current rating (amperes) Maximum voltage drop (mV) Power dissipation (W) max. 001A A 001B B 32 mA 10,000 002A A 002B B 40 mA 8,000 003A A 003B B 50 mA 7,000 004A A 004B B 63 mA 5,000 005A A 005B B 80 mA 4,000 006A
10、 A 006B B 100 mA 3,500 007A A 007B B 125 mA 2,000 008A A 008B B 160 mA 2,000 009A A 009B B 200 mA 1,700 010A A 010B B 250 mA 1,400 011A A 011B B 315 mA 1,300 012A A 012B B 400 mA 1,200 013A A 013B B 500 mA 1,000 014A A 014B B 630 mA 650 015A A 015B B 800 mA 240 016A A 016B B 1 A 200 1.6 Provided by
11、IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/2C 4 TABLE I. Characteristics - Continued. CID dash number AA59688/02- Configuration Current rating (amperes) Maximum voltage drop (mV) Power dissipation (W) max. 017A A 017B B 1.25 A 200 018A A 018B B 1.
12、6 A 190 019A A 019B B 2 A 170 020A A 020B B 2.5 A 170 1.6 021A A 021B B 3.15 A 150 022A A 022B B 4 A 130 023A A 023B B 5 A 150 024A A 024B B 6.3 A 130 2.5 TABLE II. Pre-arcing time/current characteristic (+25C 10C). Percent of current rating 210 percent 275 percent 400 percent 1000 percent Rated cur
13、rent Max. Min. Max. Min. Max. Max. 23 to 100 mA inclusive 30 min. 10 ms 500 ms 3 ms 100 ms 20 ms Above 100 mA to 6.3 A 30 min. 50 ms 2 s 10 ms 300 ms 20 ms NOTES. PIN. The PIN should be used for Government purposes to buy commercial products to this CID specification sheet. See the classification se
14、ction for PIN format example. Source of document. Other Publications AMERICAN NATIONAL STANDARDS INSTITUTE/INTERNATIONAL ELECTROTECHNICAL COMMISSION (ANSI/IEC) ANSI/IEC 60127-2 - Miniature Fuses, Part 2: Cartridge Fuse-Links. Provided by IHSNot for ResaleNo reproduction or networking permitted witho
15、ut license from IHS-,-,-A-A-59688/2C 5 (Copies of this document are available online at http:/www.ansi.org/ or from the American National Standards Institute, 25 West 43rd Street, 4th Floor, New York, NY, 10036-7406.) (Industry association specifications and standards are generally available for ref
16、erence from libraries. They are also distributed among technical groups and using Federal agencies.) Commercial products. As part of the market analysis and research effort, this CID specification sheet was coordinated with the following manufacturers of commercial products. At the time of CID speci
17、fication sheet preparation and coordination, these manufacturers were known to have commercial products that would meet the requirements of this CID specification sheet. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to only th
18、e manufacturers shown.) MFRs CAGE MFRs name and address 75915 Littelfuse Incorporated 800 E. Northwest Highway Des Plaines, IL 60016-3096 Phone number (847) 824-1188 Facsimile number (847) 391-0894 E-mail: URL: 92912 Bel Fuse Incorporated 206 Van Vorst Street Jersey City, NJ 07302-3096 Phone numbe
19、r (201) 432-0463 Facsimile number (201) 432-9542 E-mail: URL: Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/2C 6 Part number (P/N) supersession data. These CID specification sheet PINs supersede the following MFRs P/Ns as shown. This in
20、formation is being provided to assist in reducing proliferation in the Government inventory system. TABLE III. P/N supersession data. MFRs P/N 1/ MFRs P/N 1/ CID dash number AA59688/02- (see table I) MFR CAGE 75915 MFR CAGE 92912 CID dash number AA59688/02- (see table I) MFR CAGE 75915 MFR CAGE 9291
21、2 001A 217.032 N/A 013A 217.500 5SF500-R 001B 227.032 N/A 013B 227.500 5SFP500-R 002A 217.040 N/A 014A 217.630 5SF630-R 002B 227.040 N/A 014B 227.630 5SFP630-R 003A 217.050 N/A 015A 217.800 5SF800-R 003B 227.050 N/A 015B 227.800 5SFP800-R 004A 217.063 N/A 016A 217001 5SF1-R 004B 227.063 N/A 016B 227
22、001 5SFP1-R 005A 217.080 5SF080-R 017A 2171.25 5SF1.25-R 005B 227.080 5SFP080-R 017B 2271.25 5SFP1.25-R 006A 217.100 5SF100-R 018A 21701.6 5SF1.6-R 006B 227.100 5SFP100-R 018B 22701.6 5SFP1.6-R 007A 217.125 5SF125-R 019A 217002 5SF2-R 007B 227.125 5SFP125-R 019B 227002 5SFP2-R 008A 217.160 5SF160-R
23、020A 21702.5 5SF2.5-R 008B 227.160 5SFP160-R 020B 22702.5 5SFP2.5-R 009A 217.200 5SF200-R 021A 2173.15 5SF3.15-R 009B 227.200 5SFP200-R 021B 2273.15 5SFP3.15-R 010A 217.250 5SF250-R 022A 217004 5SF4-R 010B 227.250 5SFP250-R 022B 217004 5SFP4-R 011A 217.315 5SF315-R 023A 217005 5SF5-R 011B 227.315 5S
24、FP315-R 023B 227005 5SFP5-R 012A 217.400 5SF400-R 024A 21706.3 5SF6.3-R 012B 227.400 5SFP400-R 024B 21706.3 5SFP6.3-R 1/ The manufacturers P/N shall not be used for procurement to the requirements of this CID specification sheet. At the time of preparation of this CID specification sheet, the aforem
25、entioned commercial products were reviewed and could be replaced by the CID PIN shown. For actual part marking requirements, see the marking paragraph of A-A-59688. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/2C 7 CID number supersessio
26、n data. This CID supersedes Defense Supply Center, Columbus (DSCC) drawing 90031 and its dash numbers as shown. TABLE IV. CID number supersession data. CID dash number (see table I) AA59688/02- Superseded DSCC drawing number 90031- CID dash number (see table I) AA59688/02- Superseded DSCC drawing nu
27、mber 90031- 001A 001A 013A 013A 001B 001B 013B 013B 002A 002A 014A 014A 002B 002B 014B 014B 003A 003A 015A 015A 003B 003B 015B 015B 004A 004A 016A 016A 004B 004B 016B 016B 005A 005A 017A 017A 005B 005B 017B 017B 006A 006A 018A 018A 006B 006B 018B 018B 007A 007A 019A 019A 007B 007B 019B 019B 008A 008
28、A 020A 020A 008B 008B 020B 020B 009A 009A 021A 021A 009B 009B 021B 021B 010A 010A 022A 022A 010B 010B 022B 022B 011A 011A 023A 023A 011B 011B 023B 023B 012A 012A 024A 024A 012B 012B 024B 024B Changes from previous issue. Marginal notations are not used in this revision to identify changes with respe
29、ct to the previous issue due to the extensiveness of the changes. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/2C 8 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FSS Custodians: Navy - EC Preparing activity: DLA - CC DLA-
30、CC Project 5920-2009-045 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
