1、REVISIONS LTR DESCRIPTION DATE APPROVED A Update references, technical date, contact information, distribution statement. 24 April 2008 Abdonasser Abdouni B Updated the Vendor PINs. 30 July 2009 Abdonasser Abdouni Prepared in accordance with ASME Y14.100 Source control drawing REV PAGE REV STATUS OF
2、 PAGES REV B A A B PAGE 1 2 3 4 PMIC N/A PREPARED BY DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43216-5000 Ron Gary Original date of drawing 20 April 2001 CHECKED BY TITLE Lee Surowiec CONNECTOR, PLUG, ELECTRICAL, RF, SERIES N, RIGHT ANGLE, FOR LOW SMOKE CABLES APPROVED BY Rob Heber SIZE CAGE CO
3、DE DWG. NO. 01007 A 037Z3 REV B PAGE 1 OF 4 AMSC N/A 5935-E832-004 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 SIZE CAGE CODE DWG NO. A 037Z3 01007 REV A PAGE 2 NOTES: 1. Dimensions are in i
4、nches; metric equivalents are in parentheses. 2. Metric equivalents are given for reference purposes only. 3. All undimensioned pictorial configurations are for reference purposes only. 4. No safety wire holes are required. 5. Series N, pin contact interface, in accordance with MIL-STD-348. 6. Dimen
5、sion is .812 across flats. FIGURE 1. General configuration. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 SIZE CAGE CODE DWG NO. A 037Z3 01007 REV A PAGE 3 ENGINEERING DATA: This document cove
6、rs the requirements for radio frequency connectors accommodating special low smoke coaxial cables. REQUIREMENTS: These connectors shall conform to all the requirements of the latest issue of DSCC drawing 84148, figure 1 herein, and MIL-PRF 39012/5, and accommodate the cables listed in table I, with
7、the following additions and exceptions. Electrical: Shall be in accordance with MIL-PRF-39012/5. Mechanical: Shall be in accordance with MIL-PRF-39012/5 with the following additions and exceptions. No safety wire holes are required. Environmental: Shall be in accordance with MIL-PRF-39012/5. TABLE I
8、 Cable accommodation. Part or Identifying Number (PIN) 1/ 2/ Applicable cable 01007NBSA M17/220-00001 01007NBSB # M17/221-00001 01007NBSC & M17/222-00001 01007NBSD $ M17/223-00001 01007NBSE % M17/224-00001 01007NBSF M17/225-00001 1/ These connectors have captivated center contacts. 2/ These connect
9、ors are assembled using the MIL-C-22520/5 crimp tool and using the following crimp dies: M22520/5-05 # M22520/5-07 & M22520/5-29 $ M22520/5-25 % M22520/5-27 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH
10、43218-3990 SIZE CAGE CODE DWG NO. A 037Z3 01007 REV B PAGE 4 Approved sources of supply. Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed below have agreed to this drawing and a certificate of compliance has been submitted to
11、 Defense Supply Center Columbus, ATTN: DSCC-VAI, P.O. Box 3990, Columbus, OH 43218-3990 or emailed to RFConnectordla.mil . DSCC drawing PIN Vendor similar PIN 1/ Vendor CAGE number 01007NBSA (3190-1071) Superseded by 1107320A001-001 00795 01007NBSB (3190-1152) Superseded by 1107311A001-002 01007NBSC
12、 (3190-1178) Superseded by 1107348A001-001 01007NBSD (3190-1081) Superseded by 1107300A001-005 01007NBSE (3190-1200) Superseded by 1107318A001-001 01007NBSF (3190-1089) Superseded by 1107319A001-006 1/ Parts must be purchased to this DSCC PIN to assure all performance requirements and test are met. Vendor CAGE Vendor name number and address 00795 Delta Electronics 416 Cabot Street Beverly, MA 01915 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
