1、REVISIONS LTR DESCRIPTION DATE APPROVED A Update references, technical date, contact information, distribution statement. 24 April 2008 Abdonasser Abdouni B Updated the Vendor PINs. 30 July 2009 Abdonasser Abdouni Prepared in accordance with ASME Y14.100 Source control drawing REV PAGE REV STATUS OF
2、 PAGES REV B A A B PAGE 1 2 3 4 PMIC N/A PREPARED BY DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43218-3990 Ron Gary Original date of drawing 20 April 2001 CHECKED BY TITLE Lee Surowiec CONNECTOR, PLUG, ELECTRICAL, RF, SERIES TNC, FOR LOW SMOKE CABLES APPROVED BY Rob Heber SIZE CAGE CODE DWG. NO.
3、 01013 A 037Z3 REV B PAGE 1 OF 4 AMSC N/A 5935-E832-010 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 SIZE CAGE CODE DWG NO. A 037Z3 01013 REV A PAGE 2 NOTES: 1. Dimensions are in inches. Metr
4、ic equivalents are in parenthesis. 2. Metric equivalents are given for reference purposes only. 3. All undimensioned pictorial configurations are for reference purposes only. 4. No safety wire holes are required. 5. Series TNC, pin contact interface, in accordance with MIL-STD-348. 6. Dimension is .
5、562 (14.27 mm) across flats. FIGURE 1. General configuration. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 SIZE CAGE CODE DWG NO. A 037Z3 01013 REV A PAGE 3 ENGINEERING DATA: This document co
6、vers the requirements for radio frequency connectors accommodating special low smoke coaxial cables. REQUIREMENTS: These connectors shall conform to all the requirements of the latest issue of DSCC drawing 84148, figure 1 herein, and MIL-PRF 39012/26, and accommodate the cables listed in table I, wi
7、th the following additions and exceptions. Electrical: Shall be in accordance with MIL-PRF-39012/26. Mechanical: Shall be in accordance with MIL-PRF-39012/26 with the following exception: No safety wire holes are required. Environmental: Shall be in accordance with MIL-PRF-39012/26. TABLE I. Cable a
8、ccommodation. Part or Identifying Number (PIN) 1/ 2/ Applicable cable 01013TBSA M17/220-00001 01013TBSB # M17/221-00001 01013TBSC & M17/222-00001 01013TBSD $ M17/223-00001 01013TBSE % M17/224-00001 01013TBSF M17/225-00001 1/ These connectors have captivated center contacts. 2/ These connectors are a
9、ssembled using the MIL-C-22520/5 crimp tool and using the following crimp dies: M22520/5-05 # M22520/5-07 & M22520/5-29 $ M22520/5-25 % M22520/5-27 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-399
10、0 SIZE CAGE CODE DWG NO. A 037Z3 01013 REV B PAGE 4 Approved sources of supply. Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed below have agreed to this drawing and a certificate of compliance has been submitted to Defense
11、Supply Center Columbus, ATTN: DSCC-VAI, P.O. Box 3990, Columbus, OH 43218-3990 or emailed to RFConnectordla.mil . DSCC drawing PIN Vendor similar Part number 1/ Vendor CAGE number 01013TBSA (3190-1074) Superseded by 1203320A001-002 00795 01013TBSB (3190-1157) Superseded by 1203311A001-003 01013TBSC
12、3190-1183) Superseded by 1203348A001-003 01013TBSD (3190-1085) Superseded by 1203300A001-003 01013TBSE (3190-1205) Superseded by 1203318A001-001 01013TBSF (3190-1090) Superseded by 1203319A001-001 1/ Parts must be purchased to this DSCC PIN to assure all performance requirements and test are met. Vendor CAGE Vendor name number and address 00795 Delta Electronics 416 Cabot Street Beverly, MA 01915 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
