1、 MIL-B-49030/2A 21 March 2011 SUPERSEDING MIL-B-49030/2(EL) 22 November 1976 MILITARY SPECIFICATION SHEET BATTERY, DRY, BA-3036/U This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall con
2、sist of this specification sheet and MIL-B-49030. FIGURE 1. Interface and physical dimensions. AMSC N/A FSC 6135 INACTIVE FOR NEW DESIGN AFTER 23 JULY 1998 INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-B-49030/2A 2 Ltr Inches mm Min
3、Max Min Max A .500 .624 12.70 15.85 B 2.032 2.156 51.61 54.76 C 3.563 3.687 90.50 93.65 D 4.126 4.250 104.80 107.95 E .500 .624 12.70 15.85 F 2.438 2.562 61.93 65.07 G 5.750 5.874 146.05 149.20 H - 6.500 - 165.10 NOTES: 1. All dimensions shown on figure are in inches. 2. Unless otherwise specified,
4、tolerance is .062 inch. 3. Voltage and polarity markings may be placed either on the top or front face of the battery. 4. Provide insulated knurled nuts with brass inserts. 5. Metric equivalents specified in table are for general information only. FIGURE 1. Interface and physical dimensions - Contin
5、ued. REQUIREMENTS: Interface and physical dimensions: See figure 1. Nominal voltage: 45 volts. Tapped at: 22.5 volts. Usual number and type of cells: 60 “AA“ cells. Usual cell connection: Series-parallel. Terminals: Stud and nut. Weight (maximum): 3 pounds, 5 ounces. Capacity tests: When the battery
6、 is tested in accordance with the methods of examination and test of this specification, the minimum capacity-test requirements shall be as specified herein. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-B-49030/2A 3 First article inspection: V
7、ibration test. Mechanical-shock test. Insulation resistance test. Visual and mechanical (external and internal). Dimensions and weight. Battery voltage. Capacity, I, LT, and HT. Conformance inspection. Visual and mechanical (external) Dimensions and weight. Battery voltage. Insulation-resistance tes
8、t. Vibration test. Mechanical-shock test. Capacity: LT, HT, T, and D. Methods of examination and test: Capacity tests: See requirements for capacity specified herein. Test Storage period Temperature Minimum service required (hours) I (Initial 70 F) LT (0 F) HT (160 F) T D 48 hours minimum 16 hours m
9、inimum, 7 days plus 48 hours minimum 13 weeks plus 48 hours minimum 52 weeks 70 F 0 F 160 F 70 F 113 F 70 F 70 F 34 7 28 30 32 Discharge: The battery shall be discharged through 600 ohms continuously to an end voltage of 27.0 volts. Provided by IHSNot for ResaleNo reproduction or networking permitte
10、d without license from IHS-,-,-MIL-B-49030/2A 4 Closed circuit voltage: Use TS-183( )/U test per special marking or, with minimum permissible voltage as specified for TS-183 ( )/U, use a load resistant value of 544.0 ohms. Special marking on each unit package: Part or Identifying Number (PIN): BA-30
11、36/U, see 1.2 of MIL-B-49030. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and cont
12、ractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodians: Preparing activity: Army - CR DLA - CC DLA - CC (Project 6135-2010-010) NOTE: The activities listed above we
13、re interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil/. TO TEST THIS BATTERY WITH TS-183 ( )/U USE JACK NO MINIMUM PERMISSIBLE VOLTAGE 13 42.0 Unless expressly authorized, this test information shall apply to Army and Air Force applications only. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
