DLA MIL-DTL-27434 10 B-2009 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES LC SOCKET CONTACT TO SERIES N SOCKET CONTACT FLANGE MOUNT TYPE UG 71A U.pdf

上传人:progressking105 文档编号:690362 上传时间:2018-12-30 格式:PDF 页数:2 大小:31.57KB
下载 相关 举报
DLA MIL-DTL-27434 10 B-2009 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES LC SOCKET CONTACT TO SERIES N SOCKET CONTACT FLANGE MOUNT TYPE UG 71A U.pdf_第1页
第1页 / 共2页
DLA MIL-DTL-27434 10 B-2009 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES LC SOCKET CONTACT TO SERIES N SOCKET CONTACT FLANGE MOUNT TYPE UG 71A U.pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

1、MIL-DTL-27434/10B 26 May 2009 SUPERSEDING MIL-DTL-27434/10A 30 October 2008 DETAIL SPECIFICATION SHEET ADAPTER, CONNECTOR, COAXIAL, RADIOFREQUENCY, BETWEEN SERIES, SERIES LC, SOCKET CONTACT, TO SERIES N, SOCKET CONTACT, FLANGE MOUNT, TYPE UG271A/U This specification is approved for use by all Depart

2、ments and Agencies of the Department of Defense The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-27434. Inches mm Inches mm .005 .196 0.13 4.99 1.187 1.562 30.15 39.67 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given

3、 for information only. 3. Unless otherwise specified dimensional tolerances are .005 inches. FIGURE 1. Type UG 271 A/U connector adapter. AMSC N/A FSC 5935 INACTIVE FOR NEW DESIGN AFTER 19 FEBRUARY 1982 INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license f

4、rom IHS-,-,-MIL-DTL-27434/10B 2 ENGINEERING DATA: Impedance: 50 ohms, nominal. Voltage rating: 1,000 V rms, maximum at sea level. 125 V rms, maximum at 70,000 feet. Temperature rating: -65 C to +165 C. REQUIREMENTS: Dimensions and configuration: As specified on figure 1. Mating characteristics: Seri

5、es LC and series N interface shall be in accordance with MIL-STD-348. Dielectric withstanding voltage: Method 301 of MIL-STD-202, 2,500 V rms minimum at sea level. Corrosion: Applicable. Vibration: Applicable. Shock: Applicable. Part or Identifying Number (PIN): UG-271A/U. Supersession: This documen

6、t supersedes Navy drawing REB49279. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies i

7、n these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. If addition to MIL-DTL-27434, this document references the foll

8、owing: MIL-STD-202 MIL-STD-348 CONCLUDING MATERIAL Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Force - 85 (Project 5935-2009-154) DLA - CC Review activities: Navy - SH Air Force - 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • ASTM D4951-2006 Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry《用感应耦合等离子体原子发射光谱法测定润滑油中添加剂.pdf ASTM D4951-2006 Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry《用感应耦合等离子体原子发射光谱法测定润滑油中添加剂.pdf
  • ASTM D4951-2009 Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry《感应耦合等离子体原子发射光谱法测定润滑油添加元素的.pdf ASTM D4951-2009 Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry《感应耦合等离子体原子发射光谱法测定润滑油添加元素的.pdf
  • ASTM D4951-2014 Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry《用感光偶合等离子体 (ICP) 原子发射光谱法测定.pdf ASTM D4951-2014 Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry《用感光偶合等离子体 (ICP) 原子发射光谱法测定.pdf
  • ASTM D4952-2002(2007) Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫磺类物质的定量分析的标准试验方法(含硫试验)》.pdf ASTM D4952-2002(2007) Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫磺类物质的定量分析的标准试验方法(含硫试验)》.pdf
  • ASTM D4952-2009 Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫品种定性分析用标准试验方法(试硫液试验)》.pdf ASTM D4952-2009 Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫品种定性分析用标准试验方法(试硫液试验)》.pdf
  • ASTM D4952-2012 Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫物质定性分析的标准试验方法(含硫试验)》.pdf ASTM D4952-2012 Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫物质定性分析的标准试验方法(含硫试验)》.pdf
  • ASTM D4952-2012(2017) Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫类物质定性分析的标准试验方法(试硫液试验)》.pdf ASTM D4952-2012(2017) Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels and Solvents (Doctor Test)《燃料和溶剂中活性硫类物质定性分析的标准试验方法(试硫液试验)》.pdf
  • ASTM D4953-2006 Standard Test Method for Vapor Pressure of Gasoline and Gasoline-Oxygenate Blends (Dry Method)《汽油和汽油元氧混合物蒸气压力的标准试验方法(干燥法)》.pdf ASTM D4953-2006 Standard Test Method for Vapor Pressure of Gasoline and Gasoline-Oxygenate Blends (Dry Method)《汽油和汽油元氧混合物蒸气压力的标准试验方法(干燥法)》.pdf
  • ASTM D4953-2006(2012) Standard Test Method for Vapor Pressure of Gasoline and Gasoline-Oxygenate Blends (Dry Method)《汽油和汽油充氧混合物蒸气压力的标准试验方法(干法)》.pdf ASTM D4953-2006(2012) Standard Test Method for Vapor Pressure of Gasoline and Gasoline-Oxygenate Blends (Dry Method)《汽油和汽油充氧混合物蒸气压力的标准试验方法(干法)》.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1