DLA MIL-DTL-27434 24 A-2008 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES TWIN to SERIES C TYPE UG-971 U.pdf

上传人:roleaisle130 文档编号:690379 上传时间:2018-12-30 格式:PDF 页数:3 大小:66KB
下载 相关 举报
DLA MIL-DTL-27434 24 A-2008 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES TWIN to SERIES C TYPE UG-971 U.pdf_第1页
第1页 / 共3页
DLA MIL-DTL-27434 24 A-2008 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES TWIN to SERIES C TYPE UG-971 U.pdf_第2页
第2页 / 共3页
DLA MIL-DTL-27434 24 A-2008 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES TWIN to SERIES C TYPE UG-971 U.pdf_第3页
第3页 / 共3页
亲,该文档总共3页,全部预览完了,如果喜欢就下载吧!
资源描述

1、MIL-DTL-27434/24A 22 May 2008 SUPERSEDING MIL-A-27434/24 28 September 1960 DETAIL SPECIFICATION SHEET ADAPTER, CONNECTOR, COAXIAL, RADIOFREQUENCY, BETWEEN SERIES, SERIES TWIN to SERIES C TYPE UG-971/U This specification is approved for use by all Departments and Agencies of the Department of Defense

2、 The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-27434. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information only. FIGURE 1. Type UG971/U connector adapter. AMSC N/A FSC 5935 Inches mm 1.515 1.500 .605 .

3、300 38.48 38.10 15.37 7.62 Inactive for new design after 19 February 1982 INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-27434/24A 2 ENGINEERING DATA: Impedance: 50 ohms, nominal. Frequency range: 0 to 200 MHz. Voltage rating: 500

4、 V rms, maximum at sea level. 125 V rms, maximum at 70,000 feet. Temperature rating: -65 C to +165 C. REQUIREMENTS: Dimensions and configuration: See figure 1. Mating characteristics: Series C socket contact in accordance with MIL-STD-348, and series twin interface shall be in accordance with MIL-DT

5、L-27434 after assembly. Dielectric withstanding voltage: Method 301 of MIL-STD-202, 1,500 V rms minimum at sea level. Corrosion: Applicable. Vibration: Applicable. Shock: Applicable. Part or Identifying Number (PIN): UG-971/U. Supersession: This document supersedes Signal Corps Drawing SC-C-106728.

6、Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Referenced documents. In addition to MIL-DTL-27434, this document references the following: MIL-STD-202 SC-B-106736 MIL-STD-348 SC-B-

7、106737 SC-B-106730 SC-B-106739 SC-B-106731 SC-B-106740 SC-B-106732 SC-B-106741 SC-B-106733 SC-C-106742 SC-B-106735 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-27434/24A 3 CONCLUDING MATERIAL Custodians: Preparing activity: Army - CR DLA -

8、 CC Navy - EC Air Force - 85 (Project 5935-2007-010) DLA - CC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • BS EN 524-4-1997 Steel strip sheaths for prestressing tendons - Test methods - Determination of lateral load resistance《预应力钢丝索用钢带护套 试验方法 抗侧面负荷力的测定》.pdf BS EN 524-4-1997 Steel strip sheaths for prestressing tendons - Test methods - Determination of lateral load resistance《预应力钢丝索用钢带护套 试验方法 抗侧面负荷力的测定》.pdf
  • BS EN 524-5-1997 Steel strip sheaths for prestressing tendons - Test methods - Determination of tensile load resistance《预应力钢丝索用钢带护套 试验方法 抗拉负荷力的测定》.pdf BS EN 524-5-1997 Steel strip sheaths for prestressing tendons - Test methods - Determination of tensile load resistance《预应力钢丝索用钢带护套 试验方法 抗拉负荷力的测定》.pdf
  • BS EN 524-6-1997 Steel strip sheaths for prestressing tendons - Test methods - Determination of leaktightness (determination of water loss)《预应力钢丝索用钢带护套 试验方法 密闭性的测定(水损失的测定)》.pdf BS EN 524-6-1997 Steel strip sheaths for prestressing tendons - Test methods - Determination of leaktightness (determination of water loss)《预应力钢丝索用钢带护套 试验方法 密闭性的测定(水损失的测定)》.pdf
  • BS EN 525-2009 Non-domestic direct gas-fired forced convection air heaters for space heating not exceeding a net heat input of 300 kW《空间加热用净热输入不超过300 kW的非家用直接燃气式强制对流空气加热器》.pdf BS EN 525-2009 Non-domestic direct gas-fired forced convection air heaters for space heating not exceeding a net heat input of 300 kW《空间加热用净热输入不超过300 kW的非家用直接燃气式强制对流空气加热器》.pdf
  • BS EN 526-1995 Inland navigation vessels - Gangways with a length not exceeding 8 m Requirements types《内河航行船舶 长度不超过8m的跳板 要求和类型》.pdf BS EN 526-1995 Inland navigation vessels - Gangways with a length not exceeding 8 m Requirements types《内河航行船舶 长度不超过8m的跳板 要求和类型》.pdf
  • BS EN 527-1-2011 Office furniture Work tables and desks Dimensions《办公家具 工作台及桌子 尺寸规格》.pdf BS EN 527-1-2011 Office furniture Work tables and desks Dimensions《办公家具 工作台及桌子 尺寸规格》.pdf
  • BS EN 527-2-2016 Office furniture Work tables Safety strength and durability requirements《办公家具 工作台 第2部分 安全性、强度和耐久性要求》.pdf BS EN 527-2-2016 Office furniture Work tables Safety strength and durability requirements《办公家具 工作台 第2部分 安全性、强度和耐久性要求》.pdf
  • BS EN 527-3-2003 Office furniture - Work tables and desks - Methods of test for the determination of the stability and the mechanical strength of the structure《办公家具 工作台和写字台 结构的稳定性和.pdf BS EN 527-3-2003 Office furniture - Work tables and desks - Methods of test for the determination of the stability and the mechanical strength of the structure《办公家具 工作台和写字台 结构的稳定性和.pdf
  • BS EN 528-2008 Rail dependent storage and retrieval equipment - Safety requirements《轨道式存储和卸取设备 安全性要求》.pdf BS EN 528-2008 Rail dependent storage and retrieval equipment - Safety requirements《轨道式存储和卸取设备 安全性要求》.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1