DLA MIL-DTL-5423 3 D-2009 BOOT DUST AND WATER SEAL TYPE A (FOR TOGGLE SWITCHES) STYLE 4 (THREE朒OLE MOUNTING THROUGH).pdf

上传人:priceawful190 文档编号:690956 上传时间:2018-12-30 格式:PDF 页数:2 大小:31.74KB
下载 相关 举报
DLA MIL-DTL-5423 3 D-2009 BOOT DUST AND WATER SEAL TYPE A (FOR TOGGLE SWITCHES) STYLE 4 (THREE朒OLE MOUNTING THROUGH).pdf_第1页
第1页 / 共2页
DLA MIL-DTL-5423 3 D-2009 BOOT DUST AND WATER SEAL TYPE A (FOR TOGGLE SWITCHES) STYLE 4 (THREE朒OLE MOUNTING THROUGH).pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

1、INCH-POUND MIL-DTL-5423/3D 17 February 2009 SUPERSEDING MIL-DTL-5423/3C 4 February 2008 DETAIL SPECIFICATION SHEET BOOT, DUST AND WATER SEAL, TYPE A (FOR TOGGLE SWITCHES), STYLE 4 (THREEHOLE MOUNTING, THROUGH) This specification sheet is approved for use by all Departments and Agencies of the Depart

2、ment of Defense. AMSC N/A FSC 5930 The requirements for acquiring the product described herein shall consist of this specification and MIL-DTL-5423. Inches mm .005 0.13 .015 0.38 .030 0.76 .062 1.57 .115 2.92 .156 3.96 .240 6.10 .297 7.54 .432 10.97 .500 12.70 .510 12.95 750 19.05 1.812 46.02 NOTES:

3、 1. Dimensions are in inches. 2. Metric equivalents are given for general information only and are based upon 1 inch = 25.4 mm. 3. Unless otherwise specified, tolerances are .015 (0.38 mm). FIGURE 1. Boot type A, style 4. Provided by IHSNot for ResaleNo reproduction or networking permitted without l

4、icense from IHS-,-,-MIL-DTL-5423/3D 2 REQUIREMENTS: Dimensions and configuration: See figure 1. Silicon rubber: Grade 50. Restoring force: Not applicable. Operation of guards: Applicable. Sand and dust: Boots shall be mounted on the applicable switch before the switch is installed on the test enclos

5、ure. Salt spray (corrosion): Not applicable. Part or Identifying Number (PIN): M5423/03-01. Qualification: First Article Testing in accordance with MIL-DTL-5423. The margins of this specification are marked with vertical lines to indicate where modifications were made. This was done as a convenience

6、 only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations. Referenced documents: MIL-DTL-5423 Custodians: Pre

7、paring activity: Army - CR DLA - CC Navy - AS Air Force - 85 (Project 5930-2008-060) DLA - CC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at www.assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • DIN CEN ISO TS 22117-2011 Microbiology of food and animal feeding stuffs - Specific requirements and guidance for proficiency testing by interlaboratory comparison (ISO TS 22117 20.pdf DIN CEN ISO TS 22117-2011 Microbiology of food and animal feeding stuffs - Specific requirements and guidance for proficiency testing by interlaboratory comparison (ISO TS 22117 20.pdf
  • DIN CEN ISO TS 22391-7-2012 Plastics piping systems for hot and cold water installations - Polyethylene of raised temperature resistance (PE-RT) - Part 7 Guidance for the assessmen.pdf DIN CEN ISO TS 22391-7-2012 Plastics piping systems for hot and cold water installations - Polyethylene of raised temperature resistance (PE-RT) - Part 7 Guidance for the assessmen.pdf
  • DIN CEN ISO TS 27469-2011 de 1627 Petroleum petrochemical and natural gas industries - Method of test for fire dampers (ISO TS 27469 2010) English version CEN ISO TS 27469 2011《石油 .pdf DIN CEN ISO TS 27469-2011 de 1627 Petroleum petrochemical and natural gas industries - Method of test for fire dampers (ISO TS 27469 2010) English version CEN ISO TS 27469 2011《石油 .pdf
  • DIN CEN ISO TS 29001-2011 en 3376 Petroleum petrochemical and natural gas industries - Sector-specific quality management systems - Requirements for product and service supply orga.pdf DIN CEN ISO TS 29001-2011 en 3376 Petroleum petrochemical and natural gas industries - Sector-specific quality management systems - Requirements for product and service supply orga.pdf
  • DIN CEN ISO TS 6579-2-2013 de 2012 Microbiology of food and animal feed - Horizontal method for the detection enumeration and serotyping of Salmonella - Part 2 Enumeration by a min.pdf DIN CEN ISO TS 6579-2-2013 de 2012 Microbiology of food and animal feed - Horizontal method for the detection enumeration and serotyping of Salmonella - Part 2 Enumeration by a min.pdf
  • DIN CEN ISO TS 80004-12-2017 Nanotechnologies - Vocabulary - Part 12 Quantum phenomena in nanotechnology (ISO TS 80004-12 2016) German version CEN ISO TS 80004-12 2017.pdf DIN CEN ISO TS 80004-12-2017 Nanotechnologies - Vocabulary - Part 12 Quantum phenomena in nanotechnology (ISO TS 80004-12 2016) German version CEN ISO TS 80004-12 2017.pdf
  • DIN CEN ISO TS 80004-2-2017 Nanotechnologies - Vocabulary - Part 2 Nano-objects (ISO TS 80004-2 2015) German version CEN ISO TS 80004-2 2017《纳米技术 词汇 第2部分 纳米对象》.pdf DIN CEN ISO TS 80004-2-2017 Nanotechnologies - Vocabulary - Part 2 Nano-objects (ISO TS 80004-2 2015) German version CEN ISO TS 80004-2 2017《纳米技术 词汇 第2部分 纳米对象》.pdf
  • DIN CEN ISO TS 8062-2-2014 Geometrical Product Specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 2 Rules (ISO TS 8062-2 2013) German version CE.pdf DIN CEN ISO TS 8062-2-2014 Geometrical Product Specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 2 Rules (ISO TS 8062-2 2013) German version CE.pdf
  • DIN CEN TR 1317-6-2012 Road restraint systems - Part 6 Pedestrian restraint system - Pedestrian parapets German version CEN TR 1317-6 2012《道路约束系统 第6部分 行人防护体系 人行道矮墙 德文版本CEN TR 1317-.pdf DIN CEN TR 1317-6-2012 Road restraint systems - Part 6 Pedestrian restraint system - Pedestrian parapets German version CEN TR 1317-6 2012《道路约束系统 第6部分 行人防护体系 人行道矮墙 德文版本CEN TR 1317-.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1