DLA MIL-PRF-27 339 E-2010 TRANSFORMERS POWER 6 VOLTAMPERES 400 HZ.pdf

上传人:Iclinic170 文档编号:692726 上传时间:2018-12-30 格式:PDF 页数:4 大小:65.37KB
下载 相关 举报
DLA MIL-PRF-27 339 E-2010 TRANSFORMERS POWER 6 VOLTAMPERES 400 HZ.pdf_第1页
第1页 / 共4页
DLA MIL-PRF-27 339 E-2010 TRANSFORMERS POWER 6 VOLTAMPERES 400 HZ.pdf_第2页
第2页 / 共4页
DLA MIL-PRF-27 339 E-2010 TRANSFORMERS POWER 6 VOLTAMPERES 400 HZ.pdf_第3页
第3页 / 共4页
DLA MIL-PRF-27 339 E-2010 TRANSFORMERS POWER 6 VOLTAMPERES 400 HZ.pdf_第4页
第4页 / 共4页
亲,该文档总共4页,全部预览完了,如果喜欢就下载吧!
资源描述

1、AMSC N/A FSC 5950 INCH-POUND MIL-PRF-27/339E 21 June 2010 SUPERSEDING MIL-PRF-27/339D 22 January 1992 PERFORMANCE SPECIFICATION SHEET TRANSFORMERS, POWER, 6 VOLTAMPERES, 400 HZ This specification is approved for use by all Departments and agencies of the Department of Defense. The complete requireme

2、nts for procuring the transformer described herein shall consist of this document and the latest issue of specification MIL-PRF-27. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Marking shall be on the top and sides of the case. 4. Dimensional t

3、olerance shall be .031 unless otherwise specified. 5. Dimensions G and H to be measured at top of transformer. FIGURE 1. Dimensions and configurations. Ltr Dimensions Inches mm G H J K L M 1.25 .015 1.19 .015 0.88 .015 0.94 .015 1.00 .015 .250 .031 31.8 0.38 30.2 0.38 22.4 0.38 23.9 0.38 25.4 0.38 6

4、35 0.79 Inches mm .005 0.13 .010 0.25 .031 0.79 .062 .094 1.57 2.39 .116 2.95 .125 3.18.169 4.29.187 4.75 .250 6.35 .375 9.53 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/339E 2 REQUIREMENTS: (When numbers in parentheses, i.e., (1-2) a

5、re used, they indicate the winding and the extreme terminals of the winding.) Electrical ratings: Primary voltage (1-2): 115 volts rms, 400 20 hertz. Secondary voltage and current (3-5): See table I. Volt-ampere: 6 voltamperes. Working voltage (1-2): 535 volts peak. Design and construction: Dimensio

6、ns and configuration: See figure 1. Duty cycle. Continuous. Case: Encapsulated. Material: Diallyl phthalate. Terminals: Turret type. Height: .169 inch. Weight: 15 pounds, maximum. Operating temperature range. -55 to +130C. Altitude: 70,000 feet. Terminal strength: MIL-STD-202, method 211, test condi

7、tion A, 2 pounds. Dielectric withstanding voltage (each winding): At sea level: 1500 volts rms. At reduced barometric pressure: 1.25 times the peak working voltage specified. Electrical characteristics: Rated load: With 115 volts rms and 400 Hz in (1-2), and rated current in secondary, the voltage a

8、cross (3-5) shall be as specified in table I. DC resistance: (1-2): 61 ohms 25 percent. (3-5): See table I. Temperature rise: 45C with 115 volts rms, 400 hertz across (1-2) at an ambient temperature of 85C, full load terminals (3-5). Provided by IHSNot for ResaleNo reproduction or networking permitt

9、ed without license from IHS-,-,-MIL-PRF-27/339E 3 Regulation: 100)()()(xloadratedVoltageloadratedVoltageloadnoVoltage Shall not exceed 10 percent. Polarity: Additive with terminals 2 and 3 connected. Marking location: See figure 1. Part or Identifying Number (PIN): M27/339-(dash number from table I)

10、 TABLE I. Electrical ratings. Dash number M27/339 Secondary voltage (3-5) (V rms) 5% (CT) Secondary current (3-5) (amperes) Secondary DCR (3-5) (ohms) 25% -01 5.0 1.2 173 -02 6.3 .95 24-03 8.0 .75 396 -04 10.0 .60 587-05 12.6 .475 99 -06 14.0 .428 1.11-07 16.0 .375 1.58 -08 18.0 .333 2.21-09 -10 -1

11、1 -12 -13 -14 -15 -16 -17 -18 -19 -20 -21 -22 -23 -24 -25 -26 -27 -28 -29 -30 -31 -32 20.0 22.0 25.0 28.0 31.0 35.0 39.0 43.0 48.0 55.0 63.0 70.0 80.0 90.0 100.0 110.0 123.0 138.0 157.0 175.0 200.0 220.0 26.0 115.0 .300 .273 .240 .214 .192 .171 .154 .139 .125 .109 .095 .085 .075 .067 .060 .054 .048

12、043 .038 .034 .030 .027 .231 .052 2.78 2.8 3.6 4.2 5.71 6.89 9.39 10.25 15.30 17.30 24.9 27.1 39.0 41.0 59.5 68.5 96.0 133.0 153.0 168.0 248.0 278.0 3.74 65.10 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/339E 4 VERIFICATION: Extent of

13、 qualification: Qualification testing and approval to M27/338-28 and M27/343-32 shall be sufficient to grant qualification approval to MIL-PRF-27/338 through MIL-PRF-27/343 inclusive, all parts. Qualification testing and approval to M27/339-32 shall be sufficient to grant qualification approval to M

14、27/339-01 through M27/339-32. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in thes

15、e notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. MIL-PRF-27 MIL-STD-202 Custodians: Preparing activity: Army - CR DLA

16、 CC Navy - EC Air force 85 DLA - CC Review activities: (Project 5950-2009-060) Army AR, CR4 Navy - AS, MC, OS Air Force - 19, 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • STAS 6657 1-1989 CONCRETE RE1NFORCED CONCRETE AND PRESTRESSED CONCRETE ELEMENTS General technical requirements for quality《混凝土,钢筋混凝土,预应力混凝土 一般质量技术要求 》.pdf STAS 6657 1-1989 CONCRETE RE1NFORCED CONCRETE AND PRESTRESSED CONCRETE ELEMENTS General technical requirements for quality《混凝土,钢筋混凝土,预应力混凝土 一般质量技术要求 》.pdf
  • STAS 6657 2-1989 CONCRETE REINFORCED CONCRETE AND PRESTRESS CONCRETE ELEMENTS Rules and methods for quality checking up《混凝土,钢筋混凝土和预应力混凝土 质量管理规则和方式 》.pdf STAS 6657 2-1989 CONCRETE REINFORCED CONCRETE AND PRESTRESS CONCRETE ELEMENTS Rules and methods for quality checking up《混凝土,钢筋混凝土和预应力混凝土 质量管理规则和方式 》.pdf
  • STAS 6657 3-1989 CONCRETE REINFORCED CONCRETE AND PRESTRESSED CONCRETE UNTTS Inspections procedures instruments and devices of geometrical characteristics《混凝土,钢筋混凝土和预应力混凝土 几何特征的检查程.pdf STAS 6657 3-1989 CONCRETE REINFORCED CONCRETE AND PRESTRESSED CONCRETE UNTTS Inspections procedures instruments and devices of geometrical characteristics《混凝土,钢筋混凝土和预应力混凝土 几何特征的检查程.pdf
  • STAS 6661-1982 Transport acoustics NOISE EMITTED BY RAILWAY VE1I1CLES Methods for mcasurement and admissible limits《运输声学 轨道车辆的噪音 检测方法和容许界限 》.pdf STAS 6661-1982 Transport acoustics NOISE EMITTED BY RAILWAY VE1I1CLES Methods for mcasurement and admissible limits《运输声学 轨道车辆的噪音 检测方法和容许界限 》.pdf
  • STAS 6662-1987 Welded joints SHAPES AND DIMENSIONS OF EDGES FOR MANUAL ARC WELDING AND GAS WELDING《焊接接头 手工电弧焊和气焊接头边缘形状和尺寸 》.pdf STAS 6662-1987 Welded joints SHAPES AND DIMENSIONS OF EDGES FOR MANUAL ARC WELDING AND GAS WELDING《焊接接头 手工电弧焊和气焊接头边缘形状和尺寸 》.pdf
  • STAS 6663-1984 bore typE milliNg cUttErs of HyGsEEd steeL Ceneral techniral rcquireints for quality《高速钢带孔铣刀 一般质量技术要求 》.pdf STAS 6663-1984 bore typE milliNg cUttErs of HyGsEEd steeL Ceneral techniral rcquireints for quality《高速钢带孔铣刀 一般质量技术要求 》.pdf
  • STAS 6664-1984 MILUNG CUTTERS WITH INSERTEI) HIGHSPEED STEEL TEETH Gencral technieal requirements for qualitv《镶钢齿三面刃铣刀 一般质量技术要求 》.pdf STAS 6664-1984 MILUNG CUTTERS WITH INSERTEI) HIGHSPEED STEEL TEETH Gencral technieal requirements for qualitv《镶钢齿三面刃铣刀 一般质量技术要求 》.pdf
  • STAS 6665-1983 COTTON-TYPE AND COTTON WOVEN FABRICS Widths《棉织品宽度 》.pdf STAS 6665-1983 COTTON-TYPE AND COTTON WOVEN FABRICS Widths《棉织品宽度 》.pdf
  • STAS 6667-1985 CLIMATIC PROTECTION Climatic lost program《气候防护 气候项目 》.pdf STAS 6667-1985 CLIMATIC PROTECTION Climatic lost program《气候防护 气候项目 》.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1