DLA MIL-PRF-27 364 A-2010 TRANSFORMERS POWER 107 VOLTAMPERES 3-PHASE.pdf

上传人:bonesoil321 文档编号:692750 上传时间:2018-12-30 格式:PDF 页数:4 大小:87.84KB
下载 相关 举报
DLA MIL-PRF-27 364 A-2010 TRANSFORMERS POWER 107 VOLTAMPERES 3-PHASE.pdf_第1页
第1页 / 共4页
DLA MIL-PRF-27 364 A-2010 TRANSFORMERS POWER 107 VOLTAMPERES 3-PHASE.pdf_第2页
第2页 / 共4页
DLA MIL-PRF-27 364 A-2010 TRANSFORMERS POWER 107 VOLTAMPERES 3-PHASE.pdf_第3页
第3页 / 共4页
DLA MIL-PRF-27 364 A-2010 TRANSFORMERS POWER 107 VOLTAMPERES 3-PHASE.pdf_第4页
第4页 / 共4页
亲,该文档总共4页,全部预览完了,如果喜欢就下载吧!
资源描述

1、AMSC N/A FSC 5950 MIL-PRF-27/364A 21 June 2010 SUPERSEDING MIL-PRF-27/364 4 December 1986 PERFORMANCE SPECIFICATION SHEET TRANSFORMERS, POWER, 107 VOLTAMPERES, 3-PHASE This specification is approved for use by all Departments and agencies of the Department of Defense. The requirements for acquiring

2、the product described herein shall consist of this specification sheet and the latest issue of MIL-PRF-27. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Marking shall be on the sides of the case. Terminal identification shall be as shown on the

3、figure. 4. Electrical values shall be marked as specified in table I. 5. For series output connect terminals 4 and 5 together. For parallel output connect pins 3 to 4 and 5 to 6. FIGURE 1. Dimensions and configuration. INCH-POUND INCHES MM .010 .02 .090 .1380 .20 .28 .40 .43 .45 .65 .85 1.59 2.30 2.

4、50 2.74 2.94 0.25 0.5 2.29 3.505 5.1 7.1 10.2 10.9 11.4 16.5 21.6 40.4 58.4 63.5 69.6 74.7 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/364A 2 REQUIREMENTS: (When numbers in parentheses, i.e., (1-2) are used, they indicate the winding a

5、nd the extreme terminals of the winding.) Electrical ratings: Primary voltage at 400 20 Hz. Wye connected: (1-4): 115 V ac. (2-4): 115 V ac. (3-4): 115 V ac. Secondary voltage: See table I. Secondary current: See table I. Working voltage (peak): 535 volts peak maximum. Design and construction: Dimen

6、sions and configuration: See figure 1. Duty cycle: Continuous. Case: Epoxy fiberglass. Terminals: Solderable turret type. Height: 0.28 .040 inch (7.11 1.02 mm). Diameter: .090 .010 inch (2.29 0.25 mm). Weight: 1.6 pounds, maximum. Operating temperature range: -55C to +130C. Altitude: 70,000 feet, ma

7、ximum. Terminal strength: MIL-STD-202, method 211, test condition A, 5 pounds. Dielectric withstanding voltage: At atmospheric pressure (each winding): 1,500 V rms. At barometric pressure (each winding): 670 V rms. Electrical characteristics: See table II. Rated load: With rated voltage across the p

8、rimary at 400 Hz, the secondary voltages and currents shall be as specified in table I. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/364A 3 Regulation: Shall not exceed 10 percent when computed as follows: Voltage (no load) - Voltage (r

9、ated load) x 100 Voltage (rated load) TABLE I. Electrical ratings. Dash no. Delta secondary (L-L) Wye secondary (L-C) Terminals 8, 10, 12 to center tap (14) Terminals 9, 11, 13 to center tap (14) Voltage (V rms) Load current (A rms) DC resistance (ohms) Voltage (V rms) Load current (A rms) DC resist

10、ance (ohms) Voltage (V rms) Load current (A rms) DC resistance (ohms) 01 22 2.0 1.0 .38 25% 19 1.0 .578 .50 25% 19 1.0 .144 .83 25% DC resistance: Primary: (1-4): 3.25 ohms 25 percent. (2-4): 3.25 ohms 25 percent. (3-4): 3.25 ohms 25 percent. Secondary: See table I. Temperature rise: With rated volt

11、age across the primary at 400 Hz, secondary voltages and currents as specified in Table I, and a maximum ambient temperature of +80C, the temperature rise shall not exceed +50C. Shock (specified pulse): MIL-STD-202, method 213. Marking location: See figure 1. Part or Identifying Number (PIN): M27/36

12、4-01. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and

13、 contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. MIL-PRF-27 MIL-STD-202 Provided by IHSNot for ResaleNo reproduction or networking permitted w

14、ithout license from IHS-,-,-MIL-PRF-27/364A 4 Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Force - 85 (Project 5950-2009-059) DLA - CC Review activities Army CR4, MI Navy AS, MC, OS Air Force 19, 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • CEN TS 15963-2014 Bitumen and bituminous binders - Determination of the fracture toughness temperature by a three point bending test on a notched specimen《沥青和沥青粘合剂 用三点弯曲试验检在缺口试样做实验.pdf CEN TS 15963-2014 Bitumen and bituminous binders - Determination of the fracture toughness temperature by a three point bending test on a notched specimen《沥青和沥青粘合剂 用三点弯曲试验检在缺口试样做实验.pdf
  • CEN TS 15968-2010 Determination of extractable perfluorooctanesulphonate (PFOS) in coated and impregnated solid articles liquids and fire fighting foams - Method for sampling extra.pdf CEN TS 15968-2010 Determination of extractable perfluorooctanesulphonate (PFOS) in coated and impregnated solid articles liquids and fire fighting foams - Method for sampling extra.pdf
  • CEN TS 15989-2015 Firefighting and rescue service vehicles and equipment - Graphical symbols for control elements and displays and for markings《消防和救援服务车辆及设备 标记用的控制元素与显示器的图解符号》.pdf CEN TS 15989-2015 Firefighting and rescue service vehicles and equipment - Graphical symbols for control elements and displays and for markings《消防和救援服务车辆及设备 标记用的控制元素与显示器的图解符号》.pdf
  • CEN TS 16010-2013 Plastics - Recycled plastics - Sampling procedures for testing plastics waste and recyclates《塑料回收塑料 塑料垃圾和recyclates抽样程序测试》.pdf CEN TS 16010-2013 Plastics - Recycled plastics - Sampling procedures for testing plastics waste and recyclates《塑料回收塑料 塑料垃圾和recyclates抽样程序测试》.pdf
  • CEN TS 16011-2013 Plastics - Recycled plastics - Sample preparation《塑料回收塑料样品制备》.pdf CEN TS 16011-2013 Plastics - Recycled plastics - Sample preparation《塑料回收塑料样品制备》.pdf
  • CEN TS 16023-2013 Characterization of waste - Determination of gross calorific value and calculation of net calorific value《废弃物表征 总热值测定和净热值计算》.pdf CEN TS 16023-2013 Characterization of waste - Determination of gross calorific value and calculation of net calorific value《废弃物表征 总热值测定和净热值计算》.pdf
  • CEN TS 16071-2010 Interoperability of Flight Data Processing (Air Traffic Control - Air Traffic Control) for application under the Single European Sky - Interoperability Regulation.pdf CEN TS 16071-2010 Interoperability of Flight Data Processing (Air Traffic Control - Air Traffic Control) for application under the Single European Sky - Interoperability Regulation.pdf
  • CEN TS 16115-1-2011 Ambient air quality - Measurement of bioaerosols - Part 1 Determination of moulds using filter sampling systems and culture-based analyses《环境空气质量的测量 第1部分 确定模具使用.pdf CEN TS 16115-1-2011 Ambient air quality - Measurement of bioaerosols - Part 1 Determination of moulds using filter sampling systems and culture-based analyses《环境空气质量的测量 第1部分 确定模具使用.pdf
  • CEN TS 16115-2-2016 Ambient air - Measurement of bioaerosols - Part 2 Planning and evaluation of plant-related plume measurements《环境空气-测量气溶胶-第2部分 规划和植物有关羽测量评价》.pdf CEN TS 16115-2-2016 Ambient air - Measurement of bioaerosols - Part 2 Planning and evaluation of plant-related plume measurements《环境空气-测量气溶胶-第2部分 规划和植物有关羽测量评价》.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1