1、AMSC N/A FSC 5945 INCH-POUND MIL-PRF-6106/33E 22 February 2011 SUPERSEDING MIL-PRF-6106/33D 10 November 2000 PERFORMANCE SPECIFICATION SHEET RELAY, ELECTROMAGNETIC, TYPE I, 400 AMPERES, WITH 5 AMPERE AUXILIARY CONTACTS, PERMANENT MAGNET DRIVE, HERMETICALLY SEALED This specification is approved for u
2、se by all Departments and Agencies of the Department of Defense. The requirements for acquiring the relay described herein shall consist of this specification and the latest issue of MIL-PRF-6106 FIGURE 1. Dimensions and configurations.Provided by IHSNot for ResaleNo reproduction or networking permi
3、tted without license from IHS-,-,-MIL-PRF-6106/33E 2 Inches mm Inches mm .090 2.29 .970 24.60 .138 3.51 1.440 36.60.250 6.35 1.500 38.10 .266 6.76 1.930 49.00.330 8.40 2.000 50.80 .350 8.90 2.120 53.85.375 9.53 2.260 57.40 .380 9.65 2.940 74.70.550 14.00 3.000 76.20 .700 17.80 3.640 92.46 .720 18.30
4、 3.900 99.06NOTES 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. There shall be affixed to the relay a suitable legible circuit diagram that identifies each terminal location specified. 4. Permanent magnet drive consists of a permanent magnet with its f
5、lux path switched and combined with the electro-magnet flux. 5. Unless otherwise specified, tolerance is .020 (0.50 mm) for three place decimals and .03 (0.8 mm) for two place decimals. FIGURE 1. Dimensions and configurations - Continued. Provided by IHSNot for ResaleNo reproduction or networking pe
6、rmitted without license from IHS-,-,-MIL-PRF-6106/33E 3 FIGURE 2. Circuit diagrams and terminal configurations. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-6106/33E 4 NOTES: 1. To identify circuit diagrams, coil diagrams, and terminal con
7、figurations, see table I. 2. Number of terminals varies dependent upon number of auxiliary contacts. 3. Semiconductors shall be JANTX or JANTX screened. Coil diagram 3 shall continue to operate should the suppression circuit be in a failure mode (not applicable to coil diagram 2). Diodes shall have
8、a peak inverse voltage rating of 600 V dc minimum. FIGURE 2. Circuit diagrams and terminal configurations - Continued. REQUIREMENTS: Dash numbers and physical characteristics: See table I. Duty rating: Continuous. Coil data: See table II. Operational data: See table II. Contact data: See tables III
9、and IV. Contact voltage drop: Initial: 0.150 volt. After life: 0.175 volt. Overload current: 3,200 amperes dc. Rupture current: 4,000 amperes dc. Interrupt current: Carry 2,000 amperes for 7 seconds and break five times (30 minutes off per cycle). Provided by IHSNot for ResaleNo reproduction or netw
10、orking permitted without license from IHS-,-,-MIL-PRF-6106/33E 5 ELECTRICAL CHARACTERISTICS: Insulation resistance, initial: 100 megohms at 500 V dc. After life or environmental tests: 50 megohms. Dielectric withstanding voltage (sea level): Initial After life tests Coil to case 1,250 V rms 1,000 V
11、rms Auxiliary contacts 1,250 V rms 1,000 V rms All other points 1,500 V rms 1,250 V rms Dielectric withstanding voltage (altitude): 50,000 feet Coil to case 500 V rms Auxiliary contacts 500 V rms All other points 700 V rms Physical: Dimensions and configuration: See figure 1. Weight (maximum): 1.75
12、pounds. Terminal type: See figure 1, figure 2, and table II. Strength of terminals and mounting studs: Applicable. Seal: Hermetic. Finish: Painted. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-6106/33E 6 TABLE I. Mechanical and physical ch
13、aracteristics. Dash numbers Coil suppression (back EMF) Circuit diagram Coil diagram Cover height dimensions Terminal lengths 040 Not applicable B1 1 3.38 0.75 041 Applicable B1 3 3.38 0.75042 Applicable B1 3 3.38 0.75 043 Not applicable B1 1 3.38 0.75 044 Applicable B2 3 3.38 1.13045 Not applicable
14、 B2 1 3.38 1.13 046 Applicable A1 3 3.38 0.75047 Applicable A2 3 3.38 0.75 048 Not applicable A1 1 3.38 0.75 049 Not applicable A2 1 3.38 0.75 050 Applicable B2 3 3.38 0.75051 Not applicable B2 1 3.38 0.75 052 Applicable B3 3 3.38 1.13053 Not applicable B3 1 3.38 1.13 054 Applicable B3 3 3.38 0.7505
15、5 Not applicable B3 1 3.38 0.75 056 Applicable C1 3 Not applicable 1.13057 Not applicable C1 1 Not applicable 1.13 058 Applicable C1 3 Not applicable 0.75059 Not applicable C1 1 Not applicable 0.75 060 Applicable B2 2 3.38 1.13061 Applicable B3 2 3.38 1.13 062 Applicable C1 2 Not applicable 1.13063
16、Applicable B1 2 3.38 0.75 064 Applicable B1 2 3.38 0.75065 Not applicable B1 1 3.38 1.13 066 Applicable B1 3 3.38 1.13067 Applicable B1 2 3.38 1.13 068 Applicable B2 2 3.38 0.75069 Applicable A1 2 3.38 0.75 070 Not applicable A1 1 3.38 1.13 071 Applicable A1 3 3.38 1.13072 Applicable A1 2 3.38 1.13
17、073 Applicable A2 2 3.38 0.75074 Not applicable A2 1 3.38 1.13 075 Applicable A2 3 3.38 1.13076 Applicable A2 2 3.38 1.13 077 Applicable B3 2 3.38 0.75078 Applicable C1 2 Not applicable 0.75 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-610
18、6/33E 7 TABLE II. Operating characteristics. Coil data Time (milliseconds maximum) Coil dia-gram Nominal Maximum Max pickup voltage Dropout volt-age 1/ V dc Hold volt-age 1/ 2/ V dc Back EMF V dc max Oper-ate Rel-lease Contact Bounce Break bounce NO only Volts dc Res. 10% at 25C Volts dc Amp Nom-ina
19、l at 71C High temp test Contcurr-ent test Main Auxiliary NO NC NO NC 1 28 60 32 .6 18 19 21 1.5 9.0 NA 35 15 4 NA 4 4 NA 2 and 3 28 60 32 . 6 18 19 21 1.5 9.0 42 35 15 4 NA 4 4 0.1 1/ Over temperature range. 2/ Must pass random vibration test using a 9 V dc hold voltage 25C. TABLE III. Rated contact
20、 load endurance (ampere per pole) ase grounded. Type of load (Endurance) life operating cycles X 10328 V dc 28 V dc/115 400 Hz auxiliary Main NO NC D.B. S.B. Resistive 50 400 - 5 5 Inductive 20 150 - 3 Motor 1/ 2/ 50 250 - Lamp 1 1 Mechanical life Reduced current 100 100 Mixed loads Not applicable 1
21、/ Off time for motor load test shall be 6 seconds maximum. 2/ Shall also meet 20,000 cycles of special motor load as specified in table IV. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-6106/33E 8 TABLE IV. Motor load (special). 1/ 2/ Elaps
22、ed time seconds Starter current amperes 0 (initial) 1,200 1 1,0002 1,000 3 9004 8005 700 6 6007 to 60 400 1/ Must be able to meet the require- ments specified for three cycles with only 10 seconds off between cycles. At the end of three cycles, off time will be 5 minutes, minimum. 2/ The start cycle
23、 may be aborted any time during this period, requiring a contact interrupt capability of at least 1,000 amperes. ENVIRONMENTAL CHARACTERISTICS: Temperature rating: -55C to +71C. Maximum altitude rating: 50,000 feet. Shock g level: 25 gs. Duration: 9 ms. Maximum duration contact opening: 10 s. Vibrat
24、ion, sinusoidal: G level: 10 gs 5 gs Frequency range: 70-500 Hz 500-2,000 Hz. Random: 1 hr/plane 0.4 g2/Hz 15-197 cycles. 4 dB/octave increase. 197-300 cycles. 0.07 g2/Hz 300-1,000 cycles. 6 dB/octave decrease. 1,000-2,000 cycles. Acceleration: 15 gs. PART NUMBER: M6106/33- (dash number from table I
25、). Qualification by similarity: See MIL-PRF-6106. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-6106/33E 9 TABLE V. Supersession data. Superseded part number M6106/33 New part number M6106/33 Superseded part number M6106/33- New part number
26、 M6106/33- 001 040 021 060 002 041 022 061 003 042 023 062 004 043 024 063 005 044 025 064 006 045 026 065 007 046 027 066 008 047 028 067 009 048 029 068 010 049 030 069 011 050 031 070 012 051 032 071 013 052 033 072 014 053 034 073 015 054 035 074 016 055 036 075 017 056 037 076 018 057 038 077 0
27、19 058 039 078 020 059 Cross reference for Government logistics support: See table VI. TABLE VI. Cross reference for Government logis6tics support. Superseded part number M6106/33- New part number M6106/33- Support part number M6106/33- Superseded part number M6106/33- New part number M6106/33- Supp
28、ort part number M6106/33- 001 040 040 021 060 060 002 041 041 022 061 061 003 042 042 023 062 062 004 043 043 024 063 063 005 044 044 025 064 064 006 045 045 026 065 065 007 046 046 027 066 066 008 047 047 028 067 067 009 048 048 029 068 068 010 049 049 030 069 069 011 050 050 031 070 070 012 051 05
29、1 032 071 071 013 052 052 033 072 072 014 053 053 034 073 073 015 054 054 035 074 074 016 055 055 036 075 075 017 056 056 037 076 076 018 057 057 038 077 077 019 058 058 039 078 078 020 059 059 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-
30、6106/33E 10 Referenced documents. this document references the following: MIL-PRF-6106 Custodian: Preparing activity: Air Force - 85 DLA - CC DLA - CC Review activities: (Project 5945-2010-033) Air Force - 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil/. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
