1、AMSC N/A FSC 5930 MS25100K 17 March 2004 SUPERSEDING MS25100J 26 June 1995 MILITARY SPECIFICATION SHEET SWITCH, TOGGLE, TWO POLE, SEALED TOGGLE This specification is approved for use by all Depart- ments and Agencies of the Department of Defense. The requirements for acquiring the switch described h
2、erein shall consist of this specification sheet and MIL-DTL-83731. Inches mm Inches mm Inches mm Inches mm Inches mm .004 0.10 .012 0.30 .020 0.51 .03 0.8 .072 1.83 .094 2.39 .240 6.10 .432 10.97 .468 11.89 .47 11.9 .69 17.5 .719 18.26 .969 24.61 1.281 32.54 NOTES: 1. Dimensions are in inches. 2. Me
3、tric equivalents are given for information only. 3. Unless otherwise specified, tolerances are .020 (0.51 mm) on two place decimals and .005 (0.13 mm) on three place decimals. 4. For hardware detail specifications, see appendix of MIL-DTL-83731. 5. Dome on top of the mounting bushing is permissible,
4、 not to exceed .09 (2.3 mm). FIGURE 1. Dimensions and configuration. INCH-POUND MS25100K, dated 17 March 2004, is hereby reactivated and may be used for either new or existing design acquisition. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS2510
5、00K 2 Design and construction: See figure 1. Switching characteristics: See table I. Direction of the movement of the switch mechanism is the same as that of the toggle lever. Weight: .9 ounce maximum. Dielectric withstanding voltage: Sea level only. Toggle seal test: Applicable. Electrical enduranc
6、e: 10,000 cycles, at sea level only, with same polarity on adjacent poles. Electrical ratings: See table II. Mechanical endurances: Maintained circuits: 20,000 cycles Momentary circuits: 10,000 cycles. Group B inspection: Not applicable. Part or Identifying Number (PIN): Example: MS25100-22 Dash num
7、ber (see table I) PIN MS25100-22 identifies a switch with a circuit configuration of OFF in the down position (keying side), NONE in center position, and ON in the up position. TABLE I. Switching characteristics. Circuit with toggle lever in MS part number MS25100- Down position keying side Center p
8、osition Up position Former MS part number Former JAN type designation 22 Off None On MS25100-1 ST22K 23 On None On MS25100-4 ST22M 26 Mom On None On None ST12R 29 Mom Off None On MS25100-2 ST12L 30 Mom On None Off MS25100-3 ST12M Provided by IHSNot for ResaleNo reproduction or networking permitted w
9、ithout license from IHS-,-,-MS251000K 3 TABLE II. Electrical ratings. Current capacity (Amperes per pole, nominal ratings) Direct current Alternating current (60 hertz) Resistive circuit Inductive circuit Resistive circuit Inductive circuit MS part number MS25100 125 V 125 V 115 V 115 V 22 3.0 1.5 3
10、0 1.5 23 1.0 1.0 1.0 1.0 26 1.0 1.0 1.0 1.0 29 3.0 1.5 3.0 1.5 30 3.0 1.5 3.0 1.5 Referenced documents: MIL-DTL-83731 Custodians: Preparing activity: Air Force - 11 DLA - CC Navy - AS Army - CR (Project 5930-1798) DLA CC Review activities: Navy - EC Air Force - 99 Army - AV NOTE: The activities lis
11、ted above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at www.dodssp.daps.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
