1、MS27145C 17 June 2003 SUPERSEDING MS27145B 16 February 1988 DETAIL SPECIFICATION SHEET CONNECTOR, PLUG, ELECTRICAL, NO. 14 AWG, DOUBLE CONTACT, WATERPROOF This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product d
2、escribed herein shall consist of this specification. Inches mm Inches mm .010 .045 .130 .160 .244 .250 .25 1.14 3.30 4.00 6.20 6.35 .437 .625 .660 .92 .690 1.390 11.10 15.87 16.76 12.55 23.37 35.3 FIGURE 1. Configuration and dimensions. AMSC N/A 1 of 2 FSC 5935 DISTRIBUTION STATEMENT A. Approved for
3、 public release; distribution is unlimited.INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS27145C 2 REQUIREMENTS: Material: Shell: Rubber in accordance with ASTM D2000, M3BC610A14C12EO34F19. Terminal: Brass composition, temper half hard
4、minimum in accordance with ASTM B 36/B 36M, ASTM B121/B 121M or ASTM B124/B 124M. Terminal protective finish: Silver plate, grade D, class S, .0002-inch minimum thickness in accordance with ASTM B700. Mating connectors: See MS27146. When connectors are coupled, the following requirements shall apply
5、 Voltage drop: The voltage drop shall not exceed 20 millivolts when tested in a 28 volt circuit as outlined in MIL-STD-202, method 307. Dielectric strength: The assembly shall withstand dielectric strength test of 1000 volts and meet the requirements of MIL-STD-202, method 302. Waterproof requireme
6、nts: The assembly shall be waterproof. Refer to MIL-HDBK-1184, or equivalent, for guidance on waterproof testing. Salt spray corrosion test: The assembly shall meet the requirements of salt spray corrosion test outlined in MIL-STD-202, method 101 (5% saline solution, 200 hours duration). Pull test:
7、Terminal number 8338564 to be crimped to cable. Terminal number 7982997 to be soldered to cable with solder composition SN-50 or SN-60, in accordance with J-STD-004, J-STD-005, and J-STD-006. The terminal assembly shall withstand a pull test of 60 pounds (27 kilograms). Separation force: The force r
8、equired to uncouple the connectors shall not exceed 50 percent of the values expressed in the pull test above when tested at -55C and at 85C. Part or Identifying Number (PIN): MS27145-1. Details of this assembly shall be in accordance with engineering parts list 8589045, which may be obtained from t
9、he U.S. Army Tank Automotive Command, Warren, MI 48397-5000. (Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.) CONCLUDING MATERIAL Custodians: Preparing activity: Army AT DLA - CC Navy YD DLA CC (Project 5935-4427-004) Review activities: Army CR4, MI Navy MC Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
