DLA MS90539 REV D-2007 COILS RADIO FREQUENCY MOLDED FIXED SUBMINIATURE (IRON CORE) TYPES LT10K022 TO LT10K036《LT10K022到LT10K036型超小型(铁芯)固定式模制射频线圈》.pdf

上传人:feelhesitate105 文档编号:697896 上传时间:2019-01-02 格式:PDF 页数:4 大小:37.50KB
下载 相关 举报
DLA MS90539 REV D-2007 COILS RADIO FREQUENCY MOLDED FIXED SUBMINIATURE (IRON CORE) TYPES LT10K022 TO LT10K036《LT10K022到LT10K036型超小型(铁芯)固定式模制射频线圈》.pdf_第1页
第1页 / 共4页
DLA MS90539 REV D-2007 COILS RADIO FREQUENCY MOLDED FIXED SUBMINIATURE (IRON CORE) TYPES LT10K022 TO LT10K036《LT10K022到LT10K036型超小型(铁芯)固定式模制射频线圈》.pdf_第2页
第2页 / 共4页
DLA MS90539 REV D-2007 COILS RADIO FREQUENCY MOLDED FIXED SUBMINIATURE (IRON CORE) TYPES LT10K022 TO LT10K036《LT10K022到LT10K036型超小型(铁芯)固定式模制射频线圈》.pdf_第3页
第3页 / 共4页
DLA MS90539 REV D-2007 COILS RADIO FREQUENCY MOLDED FIXED SUBMINIATURE (IRON CORE) TYPES LT10K022 TO LT10K036《LT10K022到LT10K036型超小型(铁芯)固定式模制射频线圈》.pdf_第4页
第4页 / 共4页
亲,该文档总共4页,全部预览完了,如果喜欢就下载吧!
资源描述

1、 MS90539D 7 September 2007 SUPERSEDING MS90539C 11 August 1993 MILITARY SPECIFICATION SHEET COILS, RADIO FREQUENCY, MOLDED, FIXED SUBMINIATURE (IRON CORE), TYPES LT10K022 TO LT10K036 This specification is approved for use by all Depart- ments and Agencies of the Department of Defense. The requiremen

2、ts for acquiring the products described herein shall consist of this specification and MIL-PRF-15305. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. These coils are intended to be supported by their bodies. 4. Solderable/weldable lead wire, numbe

3、r 22 AWG, tinned solid copper wire. FIGURE 1. Dimensions and configuration. AMSC N/A FSC 5950 INCH-POUND Inactive for new design. Dimensions in inches with metric equivalents (mm) in parentheses LTR Minimum Maximum A B C D .180 (4.57) .430 (10.92) 1.250 (31.75) .023 (0.58) .200 (5.08) .450 (11.43) 1

4、625 (41.28) .027 (0.69) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS90539D 2 REQUIREMENTS: Design, construction, and physical dimensions: See figure 1. Style: LT10 Grade: 1 Class: A Weight: .95 grams, maximum. Operating temperature range: -55C

5、 to +105C. Ambient temperature: +90C 5C. Temperature rise: 15 C, maximum. Terminal pull: 5 pounds, minimum. Altitude: 70,000 feet. Shock (specified pulse): Method 213 of MIL-STD-202, test condition I, is applicable. Dielectric withstanding voltage (sea level): Method 301 of MIL-STD-202, test voltage

6、 700 V rms for a minimum of 60 seconds. Barometric pressure (reduced): Method 105 of MIL-STD-202, test condition C, test voltage of 180 V rms for a minimum of 60 seconds. Electrical characteristics: See tables I and II. Inductance: See table I. Q values: See table I. Self-resonant frequency (SRF): S

7、ee table I. DC resistance (DCR): See table I. Part or Identifying Number (PIN): MS90539 - (dash number from table I). Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS90539D 3 TABLE 1. Electrical characteristics (initial). Dash Number MS90539 1/ Typ

8、e Designa-tion Inductance (H) 5% Q (min) Test Frequency (MHz) SRF Minimum (MHz) DC resistance Max. (ohms) Rated DC current (mA) -01 LT10K022 270 65 .79 5.6 8.2 110 -02 LT10K023 300 65 .79 5.3 8.7 107 -03 LT10K024 330 65 .79 5.0 9.1 105 -04 LT10K025 360 65 .79 4.7 9.6 102 -05 LT10K026 390 65 .79 4.5

9、10.0 100 -06 LT10K027 430 65 .79 4.3 10.6 97 -07 LT10K028 470 65 .79 4.0 11.1 95 -08 LT10K029 510 65 .79 3.8 11.6 93 -09 LT10K030 560 65 .79 3.6 12.3 91 -10 LT10K031 620 60 .79 3.5 13.0 88 -11 LT10K032 680 60 .79 3.4 13.7 85 -12 LT10K033 750 60 .79 3.3 14.4 83 -13 LT10K034 820 60 .79 3.1 15.1 81 -14

10、 LT10K035 910 60 .79 2.9 15.8 79 -15 LT10K036 1000 60 .79 2.24 16.5 78 1/ The polarizing voltage during the moisture resistance tests is applied with the positive lead connected to the coil terminals tied together, and the negative lead connected to the metal strap. TABLE II. Electrical characterist

11、ics (final). Allowable variation from Initial measurement Allowable percent from specified minimum value in electrical characteristics (initial) table Inspection group Inductance (percent) DC resistance Self-resonant frequency Q Qualification inspection Group II Group III Group IV 2 5 5 - (3% +.001

12、ohm) (2% +.001 ohm) - -8 -10 -10 -10 -15 Conformance inspection group C Subgroup I Subgroup II Subgroup III 2 5 5 - (2% +.001 ohm) (3% +.001 ohm) - -10 -8 -10 -15 -10 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS90539D 4 Changes from previous is

13、sue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to

14、evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. MIL-PRF-15305 MIL-STD-202 Custodians: Preparing activity: Army CR DLA CC Navy - EC Air Force - 11 DLA CC Project 5950-2007-

15、046 Review activities: Army AR, MI Navy AS, MC, OS, SH Air Force 19 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • DIN VDE 0207-21-1993 Insulating and sheathing compounds for cables and flexible cords rubber sheathing compounds《电缆和软线用的绝缘和护套复合物 橡胶护套复合物》.pdf DIN VDE 0207-21-1993 Insulating and sheathing compounds for cables and flexible cords rubber sheathing compounds《电缆和软线用的绝缘和护套复合物 橡胶护套复合物》.pdf
  • DIN VDE 0207-4-1986 Insulating and sheathing compounds for cables and flexible cords PVC insulating compounds《电缆和绝缘导线用绝缘复合物和套管用复合物 PVC绝缘复合物》.pdf DIN VDE 0207-4-1986 Insulating and sheathing compounds for cables and flexible cords PVC insulating compounds《电缆和绝缘导线用绝缘复合物和套管用复合物 PVC绝缘复合物》.pdf
  • DIN VDE 0207-5-1986 Insulating and sheathing compounds for cables and flexible cords PVC sheathing compounds《电缆和绝缘导线用绝缘复合物和套管用复合物 PVC套管复合物》.pdf DIN VDE 0207-5-1986 Insulating and sheathing compounds for cables and flexible cords PVC sheathing compounds《电缆和绝缘导线用绝缘复合物和套管用复合物 PVC套管复合物》.pdf
  • DIN VDE 0207-6-2004 Insulating and sheathing compounds for cables and flexible cords - Fluorinated polymers《电缆和软导线用绝缘和铠装复合物 含氟的聚合物》.pdf DIN VDE 0207-6-2004 Insulating and sheathing compounds for cables and flexible cords - Fluorinated polymers《电缆和软导线用绝缘和铠装复合物 含氟的聚合物》.pdf
  • DIN VDE 0250-102-1991 Cables wires and flexible cords for power installation PVC-insulated twin-cable for internal wiring《电力装置用电缆、电线和软线定义 第102部分 双芯聚氯乙烯绝缘电缆》.pdf DIN VDE 0250-102-1991 Cables wires and flexible cords for power installation PVC-insulated twin-cable for internal wiring《电力装置用电缆、电线和软线定义 第102部分 双芯聚氯乙烯绝缘电缆》.pdf
  • DIN VDE 0250-204-2000 Cables wires and cords for power installation - PVC-Installation cable NYM《电力设备用电缆、电线和软线 PVC护套电缆NYM》.pdf DIN VDE 0250-204-2000 Cables wires and cords for power installation - PVC-Installation cable NYM《电力设备用电缆、电线和软线 PVC护套电缆NYM》.pdf
  • DIN VDE 0250-502-1985 Cables wires and flexible cords for power installation heat-resistant silicone wire《电力设施用电缆、电线和绝缘导线 耐热硅树脂灯头接线》.pdf DIN VDE 0250-502-1985 Cables wires and flexible cords for power installation heat-resistant silicone wire《电力设施用电缆、电线和绝缘导线 耐热硅树脂灯头接线》.pdf
  • DIN VDE 0250-602-1985 Cables wires and flexible cords for power installation special rubber-insulated single-core cables《电力设施用电缆、电线和绝缘导线 特种橡胶绝缘单芯电缆》.pdf DIN VDE 0250-602-1985 Cables wires and flexible cords for power installation special rubber-insulated single-core cables《电力设施用电缆、电线和绝缘导线 特种橡胶绝缘单芯电缆》.pdf
  • DIN VDE 0253-1987 Heating cables《供热电缆》.pdf DIN VDE 0253-1987 Heating cables《供热电缆》.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1