1、 EIA STANDARD TP-62A TERMINAL STRENGTH TEST PROCEDURE FOR ELECTRICAL CONNECTORS, AND SOCKETS EIA-364-62A (Revision of EIA-364-62) July 2004 ELECTRONIC COMPONENTS, ASSEMBLIES 1 cycle constitutes moving one direction in the same plane from the original position and then returning to the original posit
2、ion. 4.1.2 If the terminals are not capable of being bent with the fingers, or if the method of bending is critical, the individual specification shall specify the method of bending and any fixture required to control the point of application. EIA-364-62A Page 2 4.2 Solderless wrap terminals (torque
3、 and bending) 4.2.1 A torque of 0.014 newton-meter (2.0 ounce-inches) shall be applied clockwise and then counterclockwise in a plane perpendicular to the axis of the terminal. The force shall be applied gradually to the terminal and then maintained for a period of 5 seconds to 15 seconds. 4.2.2 At
4、completion of the torque test the specimens shall be subjected to the bending test as described in 4.1. 5 Details to be specified The following details shall be specified in the referencing document: 5.1 Applicable tests 5.2 Method of bending and fixture required, if critical 5.3 Number of terminati
5、ons to be tested 5.4 Number of bends if other than 2 5.5 Any deviation from the standard test method 6 Test documentation Documentation shall contain the details specified in clause 5, with any exceptions, and the following: 6.1 Title of test 6.2 Specimen description 6.3 Test equipment used, and date of last and next calibration 6.4 Test and procedure and sequence 6.5 Values and observations 6.6 Name of operator and date of test
