1、 EIA STANDARD TP-99 Gage Location and Retention Test Procedure for Electrical Connectors EIA-364-99 June 1999 ELECTRONIC COMPONENTS, ASSEMBLIES see 4.1 and 4.25.2 Reference point for gage location measurement; see 4.1EIA-364-99Page 35.3 Maximum allowable displacement after initial load has been appl
2、ied, if other than specifiedherein; see 4.25.4 Applied axial load; see 4.26 Test documentationDocumentation shall contain the details specified in clause 5, with any exceptions, and thefollowing:6.1 Title of test6.2 Specimen description; include fixture, if applicable6.3 Test equipment used, and dat
3、e of last and next calibration6.4 Values and observations6.4.1 Measured gage displacement6.5 Name of operator and date of testEIA Document Improvement ProposalIf in the review or use of this document, a potential change is made evident for safety, health or technicalreasons, please fill in the appro
4、priate information below and mail or FAX to:Electronic Components Industry AssociationEngineering Department Publications Office4212 Rock Hill Road, Suite 170Herndon, VA 20170-4212Phone: (571) 323-0294Document No. Document Title:Submitters Name: Telephone No.:FAX No.:e-mail:Address:Urgency of Change:Immediate: At next revision:Problem Area:a. Clause Number and/or Drawing:b. Recommended Changes:c. Reason/Rationale for Recommendation:Additional Remarks:Signature: Date:FOR EIA USE ONLYResponsible Committee:Chairman:Date comments forwarded to Committee Chairman:
