EN 14187-8-2003 Cold applied joint sealants - Part 8 Test method for the determination of the artificial weathering by UV-irradiation《低温用接缝密封剂 第8部分 用紫外线辐射法进行人工风化的测定的试验方法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

CSN 21 0715-1989 Forming machines Automatic forming machines Safety requirements concerning design《成形加工机械金属成形加工自动机械设计安全要求》.pdf

CSN 21 0716-1989 Forming machines Machine hammers Safety regulations for construction《成形加工机械锤子安全使用规则》.pdf

CSN 21 0731-1987 Forming machines Three- and four-roll bending machines Safety requirements concerning design《成形加工机械弯辊系统安全使用规则》.pdf

CSN 21 0732-1990 Forming machines Straightening machines Safety requirements for construction of straightening machines《成形加工机械矫直机械安全使用规则》.pdf

CSN 21 1301-1982 Forming machines Flat forming presses Coordination of t-grooves and presses dimensions of holes for inserting screws into t-grooves《金属片成形加工上压机T形槽及上压机组合T形槽嵌入螺丝钉孔洞的尺.pdf

CSN 21 1302-1982 Forming machines Flat forming presses Dimensions of ejector《金属片成形加工上压机顶杆尺寸》.pdf

CSN 21 1303-1982 Forming machines Flat forming presses Configuration of t-slots and holes for the clamping of forming tools and of holes for ejector pins and ejectors《金属片成形加工上压机 成形.pdf

CSN 21 1305-1982 Forming machines Flat forming presses Dimensions of ejector pin and ejector holes《金属片成形加工上压机 喷射器孔尺寸》.pdf

CSN 21 1306-1982 Forming machines Flat forming presses Dimensions of stem holes in rams《金属片成形加工上压机干孔尺寸》.pdf