EN 61191-4-1998 en Printed Board Assemblies Part 4 Sectional Specification Requirements for Terminal Soldered Assemblies《印制板组装 第4部分 分规范 引出端焊接组装的要求 IEC 61191-4 1998》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

CSN 24 1449-1987 Clamping screws heads for spindles with steep taper hollows《带大锥凹洞的心轴紧固螺丝头》.pdf

CSN 24 1477-1975 Reduction sleeves with Morse taper shanks and hollows《带莫氏锥度及凹洞的过渡套》.pdf

CSN 24 1478-1975 Couplings for reduction sleeves with Morse taper shanks and hollows《带大锥柄及莫氏凹洞的过渡套》.pdf

CSN 24 1481-1971 Reduction sleeves with steep taper shanks and taper Morse hollows《带大锥柄及莫氏凹洞的过渡套》.pdf

CSN 24 1483-1971 Couplings for reduction sleeves with steep taper shanks and steep or Morse hollows《带大锥柄及莫氏凹洞的过渡套耦合》.pdf

CSN 24 1487-1961 Fixed reduction sleeves with steep taper and Morse cavity《带大锥度及莫氏凹洞的固定过渡套》.pdf

CSN 24 1506-1964 Automatic screw die head for male thread Technicla code《外螺纹用自动螺丝机头 技术规范》.pdf

CSN 24 1511-1971 Shell taps holders《带壳丝锥固定器》.pdf

CSN 24 1520-1983 Metal-cutting tool clamping Round die stock wrenches manual Dimensions General requirements《金属切割刀具夹 手动圆板牙托柄扳手 尺寸 一般要求 》.pdf