1、 ETSI TS 103 901 V1.1.1 (2015-06) PowerLine Telecommunications (PLT); Coexistence of Narrow Band PLT technologies operating in the frequency bands 3kHz to 95 kHz, 95 kHz to 125 kHz and 125 kHz to 140 kHz; IEEE Std 1901.2TM - 2013, IEEE Standard for Low-Frequency (less than 500 kHz) Narrowband Power
2、Line Communications for Smart grid Applications, Section 10 Coexistence TECHNICAL SPECIFICATION ETSI ETSI TS 103 901 V1.1.1 (2015-06)2 Reference DTS/PLT-00038 Keywords endorsement, modem, powerline, smart grid ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 0
3、0 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice The present document can be downloaded from: http:/www.etsi.org/standards-search The present document may be made available in electronic
4、 versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing documen
5、t is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is
6、 available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: https:/portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any m
7、eans, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. Eu
8、ropean Telecommunications Standards Institute 2015. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTMand the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Par
9、tners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. ETSI ETSI TS 103 901 V1.1.1 (2015-06)3 Contents Intellectual Property Rights 4g3Foreword . 4g3Modal verbs terminology 4g31 Scope 5g32 References 5g32.1 Normative references . 5g32.2 Informative references 5g3End
10、orsement notice 6g3History 7g3ETSI ETSI TS 103 901 V1.1.1 (2015-06)4 Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non
11、-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/ipr.etsi.org). Pursu
12、ant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present docu
13、ment. Foreword This Technical Specification (TS) has been produced by ETSI Technical Committee Powerline Telecommunications (PLT). Modal verbs terminology In the present document “shall“, “shall not“, “should“, “should not“, “may“, “need not“, “will“, “will not“, “can“ and “cannot“ are to be interpr
14、eted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of provisions). “must“ and “must not“ are NOT allowed in ETSI deliverables except when used in direct citation. ETSI ETSI TS 103 901 V1.1.1 (2015-06)5 1 Scope The present document provides the requirements to
15、 support coexistence within the frequency band 3kHz up to 95 kHz, sub-band above 95 kHz up to 125 kHz and sub-band above 125 kHz up to 140 kHz as given in CENELEC EN 50065-1 i.7 (also referred to as the CENELEC A band, B and C bands), for the following standards: IEEE Std 1901.2TM1. IEC 61334-3-1 i.
16、1. IEC 61334-4-32 i.2. IEC 61334-5-1 i.3. IEC 61334-5-2 i.4. ISO/IEC 14543-3-5 i.5. ISO/IEC 14908-3 i.6. 2 References 2.1 Normative references References are either specific (identified by date of publication and/or edition number or version number) or non-specific. For specific references, only the
17、 cited version applies. For non-specific references, the latest version of the reference document (including any amendments) applies. Referenced documents which are not found to be publicly available in the expected location might be found at http:/docbox.etsi.org/Reference. NOTE: While any hyperlin
18、ks included in this clause were valid at the time of publication, ETSI cannot guarantee their long term validity. The following referenced documents are necessary for the application of the present document. 1 IEEE Std 1901.2TM- 2013: “IEEE Standard for Low-Frequency (less than 500 kHz) Narrowband P
19、ower Line Communications for Smart grid Applications“, section 10 Coexisitence. 2.2 Informative references References are either specific (identified by date of publication and/or edition number or version number) or non-specific. For specific references, only the cited version applies. For non-spec
20、ific references, the latest version of the reference document (including any amendments) applies. NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee their long term validity. The following referenced documents are not necessary for the app
21、lication of the present document but they assist the user with regard to a particular subject area. i.1 IEC 61334-3-1: “Distribution automation using distribution line carrier systems - Part 3-1: Mains signalling requirements - Frequency bands and output levels“. i.2 IEC 61334-4-32:“ Distribution au
22、tomation using distribution line carrier systems - Part 4: Data communication protocols - Section 32: Data link layer - Logical link control (LLC). i.3 IEC 61334-5-1: “Distribution automation using distribution line carrier systems - Part 5-1: Lower layer profiles - The spread frequency shift keying
23、 (S-FSK) profile“. i.4 IEC 61334-5-2: “Distribution automation using distribution line carrier systems - Part 5-2: Lower layer profiles - Frequency shift keying (FSK) profile“. ETSI ETSI TS 103 901 V1.1.1 (2015-06)6 i.5 ISO/IEC 14543-3-5: “Information technology - Home electronic system (HES) archit
24、ecture - Part 3-5: Media and media dependent layers - Power line for network based control of HES Class 1“. i.6 ISO/IEC 14908-3:“ Information technology - Control network protocol - Part 3: Power line channel specification“. i.7 CENELEC EN 50065-1: “Signalling on low-voltage electrical installations
25、 in the frequency range 3 kHz to 148,5 kHz - Part 1: General requirements, frequency bands and electromagnetic disturbances“. Endorsement notice All elements of Section 10, IEEE Std 1901.2TM 1 - 2013: “IEEE Standard for Low-Frequency (less than 500 kHz) Narrowband Power Line Communications for Smart grid Applications“ coexistence apply. ETSI ETSI TS 103 901 V1.1.1 (2015-06)7 History Document history V1.1.1 June 2015 Publication
