1、 ETSI TS 183 010 V2.0.0 (2008-06)Technical Specification Telecommunications and Internet converged Services andProtocols for Advanced Networking (TISPAN);NGN Signalling Control Protocol;Communication HOLD (HOLD) PSTN/ISDN simulation services;Protocol specificationETSI ETSI TS 183 010 V2.0.0 (2008-06
2、) 2 Reference RTS/TISPAN-03179-NGN-R2 Keywords hold, supplementary service ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06)
3、 N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the referenc
4、e version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change
5、of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:/portal.etsi.org/chaircor/ETSI_support.asp Copyright No
6、tification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2008. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the
7、ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. ETSI ETSI TS 183 010 V2.0.0 (2008-06) 3 Contents Intellectual Property Rights4 Foreword.4 1 Scope 5 2 Referen
8、ces 5 2.1 Normative references .5 2.2 Informative references6 3 Definitions and abbreviations.6 3.1 Definitions6 3.2 Abbreviations .6 4 Communication Hold (HOLD) 6 Annex A (informative): Signalling Flows .7 History 8 ETSI ETSI TS 183 010 V2.0.0 (2008-06) 4 Intellectual Property Rights IPRs essential
9、 or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially E
10、ssential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ET
11、SI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Specification (TS) has been produced by ETSI Technical Committee T
12、elecommunications and Internet converged Services and Protocols for Advanced Networking (TISPAN). ETSI ETSI TS 183 010 V2.0.0 (2008-06) 5 1 Scope The present document specifies the, stage three, Protocol Description of the Communication Hold (HOLD) services, based on stages one and two of the ISDN H
13、old (HOLD) supplementary services. 2 References References are either specific (identified by date of publication and/or edition number or version number) or non-specific. For a specific reference, subsequent revisions do not apply. Non-specific reference may be made only to a complete document or a
14、 part thereof and only in the following cases: - if it is accepted that it will be possible to use all future changes of the referenced document for the purposes of the referring document; - for informative references. Referenced documents which are not found to be publicly available in the expected
15、 location might be found at http:/docbox.etsi.org/Reference. For online referenced documents, information sufficient to identify and locate the source shall be provided. Preferably, the primary source of the referenced document should be cited, in order to ensure traceability. Furthermore, the refer
16、ence should, as far as possible, remain valid for the expected life of the document. The reference shall include the method of access to the referenced document and the full network address, with the same punctuation and use of upper case and lower case letters. NOTE: While any hyperlinks included i
17、n this clause were valid at the time of publication ETSI cannot guarantee their long term validity. 2.1 Normative references The following referenced documents are indispensable for the application of the present document. For dated references, only the edition cited applies. For non-specific refere
18、nces, the latest edition of the referenced document (including any amendments) applies. 1 Void. 2 Void. 3 Void. 4 Void. 5 Void. 6 Void. 7 ETSI TS 124 410: “Digital cellular telecommunications system (Phase 2+); Universal Mobile Telecommunications System (UMTS); TISPAN; NGN Signalling Control Protoco
19、l; Communication HOLD (HOLD) PSTN/ISDN simulation services; Protocol specification (3GPP TS 24.410 Release 8)“. ETSI ETSI TS 183 010 V2.0.0 (2008-06) 6 2.2 Informative references The following referenced documents are not essential to the use of the present document but they assist the user with reg
20、ard to a particular subject area. For non-specific references, the latest version of the referenced document (including any amendments) applies. Not applicable. 3 Definitions and abbreviations 3.1 Definitions For the purposes of the present document, the terms and definitions given in TS 124 410 7 a
21、pply. 3.2 Abbreviations For the purposes of the present document, the abbreviations given in TS 124 410 7 apply. 4 Communication Hold (HOLD) The provisions of the present document are contained in TS 124 410 7. ETSI ETSI TS 183 010 V2.0.0 (2008-06) 7 Annex A (informative): Signalling Flows Information is contained in TS 124 410 7. ETSI ETSI TS 183 010 V2.0.0 (2008-06) 8 History Document history V2.0.0 June 2008 Publication
