1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions 2013 12 11 N Status No replacement named L. Sinclair, NA 2007 06 27 Revised Inserted 3.0; Deleted 3.5 & 4 1966 04 18 Released TV1 #635 Controlled document at www.MATS Copyright 2013, Ford Global Technologies, LLC Page 1 of 2 ADHESION REQUIREM
2、ENTS, DRYBACK WEATHERSTRIP ADHESIVE ESB-M11P9-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE This specification defines the performance requirements for a dryback adhesive applied to closed cell sponge rubber weatherstrip. 2. APPLICATION This specification was released originally for material used where m
3、aximum adhesion is required between the closed cell sponge rubber weatherstrip and enameled metal. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.
4、1 DOUBLE COAT ADHESION 3.1.1 Normal Open Assembly Time Adhesion, min 1 min 9 psi (62 kPa) 3 min 15 psi (104 kPa) 5 min 15 psi (104 kPa) Test Method 1. Apply a 0.010 in (0.25 mm) film of ESB-M2G14-A to a steel panel painted per FLTM BI 103-02, Method “C“, using ESB-M6J49 primer and ESB-M32J100 enamel
5、 2. Allow to air dry for specified open times. 3. Apply a 2 in (50 mm) section of coated weatherstrip to the adhesive and press down firmly to insure adequate wet out. 4. Allow samples to air dry 10 min. 5. Pull weatherstrip from panel 90 to the surface of the panel at 1 in (25 mm)/min and record v
6、alues in psi (kPa). 6. A minimum of 3 samples shall be run at each open time. ENGINEERING MATERIAL SPECIFICATION ESB-M11P9-A Copyright 2013, Ford Global Technologies, LLC Page 2 of 2 3.1.2 Aged, min 25 psi (173 kPa) Test Method: Prepare samples per para 3.1.1 steps 1, 2, and 3. Allow samples to air
7、dry for 4 h at 23 +/- 2 C and 52 +/- 5% R.H. Age assemblies for 2 weeks in a mechanical convection oven at 70 +/- 1 C. Cool to 23 +/- 2 C for 1 h. Pull samples to destruction per 3.1.1, step 5. 3.2 SOFTENING POINT, min 77 C (ASTM D 816, except prepare sample as outlined in para 3.1.1 using a 1 in2 (
8、645 mm2) bonded area and 3 min open time.) 3.3 BLOCKING Coated sponge weatherstrips shall not develop adhesion to themselves great enough to cause lifting of the adhesive film or tearing of the sponge after exposure to 38 +/- 1 C for 48 h. Test Method: Place the coated surfaces of two, 6 in (150 mm)
9、 lengths of weatherstrip in intimate contact with each other, securing with a wrap of kraft paper or masking tape. Expose to a temperature of 38 +/- 1 C for 48 h. Cool to 23 +/- 2 C, remove wrapping and hand separate the weatherstrips. 3.4 APPLICATION The applied coating shall be smooth and uniform with no skips or other film defects detrimental to normal production operation.
