1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Para. No. Revisions 2012 02 28 N Status No replacement named N. Benipal, NA 1978 07 14 Metricated and Retyped CE3H-RD782440-E 1975 02 13 Released C2D3-EC773055-E WP 3948-a Page 1 of 2 COLOR IDENTIFICATION ESE-M99P7-A NOT TO
2、BE USED FOR NEW DESIGN 1. SCOPE This specification defines the performance requirements for color coding engine components. 2. APPLICATION This specification was released originally for material used for color identification of engine vacuum tubing and other specified mating components. 3. REQUIREME
3、NTS (WHERE APPLICABLE) 3.1 COLOR To be as stated below and/or approved by the affected product engineering and materials engineering departments. Approved color panels must be available at the supplier location. In case of dispute a master color chip will be available in the affected product materia
4、ls office. Color W.T. Color Number* (Ford Motor) White 0047 or 0137 Tan 3143 or 3162 Red 4040 or 4086 Orange 5038 or 5062 Yellow 6066 or 6336 Green 7322 or 7349 Blue 8002 or 8140 Pink 9036 *Standard Master W.T. color panels are available in the Ford Motor Special Paint Selector. The Special Paint Se
5、lector can be obtained from the DSI Corporation, 101 Union Street, Plymouth, Michigan 48170. 3.2 MECHANICAL PROPERTIES 3.2.1 Initial Adhesion Must withstand normal handling and shipping without flaking, chipping or peeling. 3.2.2 Thickness Substrate is not visible through the film. ENGINEERING MATER
6、IAL SPECIFICATION ESE-M99P7-A WP 3948-b Page 2 of 2 3.3 RESISTANCE PROPERTIES 3.3.3 Humidity Resistance Place a 10 in (254 mm) long sample into a humidity cabinet set at a minimum of 95 % relative humidity and 38C for 70 h. After removal from the cabinet and cooling to room temperature bend the tubi
7、ng so the ends just touch. There should be no flaking, chipping or peeling and only slight fading or color change of the identification stripe. 3.4 SUPPLIERS RESPONSIBILITY Material supplied to this specification must be equivalent to that originally approved. Changes in formulation or processing sh
8、all not be made without prior approval as described in Supplier Procedure I-A. 4. APPROVAL OF SUPPLIERS Suppliers to this specification must be approved by the affected product engineering office. Procedure for gaining approval of a specific material to a new/existing ES-M specification is contained in Supplier Procedure I-A. Approved new suppliers will be added to the Engineering Materials Approved Source List.
