1、 FORD LABORATORY TEST METHOD EU-BV 054-04 Date Action Revisions 2000 11 14 Revised Editorial no technical change A. Cockman 1994 02 28 Printed copies are uncontrolled Page 1 of 4 Copyright 2000, Ford Global Technologies, Inc. ADHESION OF SOUND DEADENER SHEETS AND PADS Application This method is used
2、 to determine the adhesion strength of Sound Deadener sheets and pads. Method A: For self-adhering pads and sheets. Method B: For heat-fusible pads and sheets. Apparatus Required Test Panels (see drawing) Steel Body Skin Panels, surface roughness 0.9 - 1.8 micrometre C.L.A. Dimensions: Upper Panel 6
3、0 x 50 x 0.8 mm Lower Panel 60 x 65 x 0.8 mm Preparation: Freshly prepared as required by the relevant Materials Specification as follows: Type I: Oiled surface according to FLTM EU-BV 50-11 - Normal Grade. Type II: Electrocoated surface prepared according to the technique outlined in FLTM EU-BI 20-
4、1, using a released material. Alternatively, panels can be electrocoated in the normal production process. Mechanical Convection Oven Capable of maintaining temperatures up to 250 C within 2 C. Tensile Machine With a constant rate of jaw separation of 25 mm/minute and an autographic recording device
5、 Test Fixture See Drawing 3. Silicone Paper Strips 25 mm wide and 60 mm long. FORD LABORATORY TEST METHOD EU-BV 054-04 Page 2 of 4 Copyright 2000, Ford Global Technologies, Inc. Conditioning and Test Conditions All test values indicated herein are based on material conditioned in a controlled atmos
6、phere of 23 +/- 2 C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Preparation of Test Assembly 1. Prepare the test assembly according to drawing 1 using the 2 test panels inserting the strip of silicone paper
7、 as shown in drawing. 2. The pretreatment of the panels must be as required by the relevant Material Specification, either as: Type I - Oiled surfaces or Type II - Electrocoated surfaces 3. The adhesion of the material under test to the panels is achieved: Method A: For self-adhering pads - by hand
8、pressure at 23 +/- 2 C. Method B: For heat-fusible pads - by heating to the temperature specified in the relevant Material Specification. Procedure Note: 3 test assemblies required unless otherwise specified. 1. After preparation according to Method A or B, condition test assemblies for 2 h at 23 +/
9、 2 C. 2. Fit the test assembly into the fixture as shown in drawing 2 and test for adhesion strength in the tensile machine at a jaw separation rate of 25 mm/ minute. Evaluation Calculate the adhesion strength as follows: Adhesion Strength (kgf/cm) = Maximum load (kgf) Width of material under test
10、cm) All test assemblies must meet the maximum requirements of the Specification. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD EU-BV 054-04 Page 3 of 4 Copyright 2000, Ford Global Technologies, Inc. ADHESION OF SOUND DEADENER SHEETS AND PADS FORD LABORATORY TEST METHOD EU-BV 054-04 Page 4 of 4 Copyright 2000, Ford Global Technologies, Inc. ADHESION OF SOUND DEADENER SHEETS AND PADS
