1、FORC MANUFACTURING STANOARDS SBl-I JULY, 1988 REVERS I BLE TERRY CLOTH GLOVE WITH DUCK GAUNTLET SBI-1 Page 1 1. USAGE: The safety unit must approve this glove prior to usage. The glove should not be used to handle sheet metalstamping, except those measuring less than 6 inches (152rms) in the longest
2、 dimension. 2. HATER1 AL: 2.1 The terry cloth is to be produced from 15/16 inch (23.7mm) stapie weighing 24 ounces per square yard. 2.2 Gauntlet material is to be 0.8 white numbered duck lb-ounce weight per square yard without sizing. 2.3 Thread used in construction of the glove is to be 24/4 Sak qu
3、ality. Haterial entering into the manufacture of this giove must be ofsuch quality as to produce a glove which will be impervious td normal dry cleaning and laundering processes. 39 SIZE (HINIHUH DIHENSIONS): Length from tip of middle finger to . base of gauntlet 8 Width of palm at thumb crotch Gaun
4、tlet length Gauntlet width at base of glove Gauntlet flare at top i nches (203mm) nches (127mm) nches /2 inches %$ /4 inches (1841nm) 4. CONSTRUCTION: Reversible is to be finished on three the glove body inseam wi th eight stitches per inch. inseam with forge loop side out. The gauntlet sides with o
5、vercast stitchi ng and banded to double stitching row. All seams must be sewn 5. SUPPLIERS RESPONSIBILITY: All material supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted, and shall be satisfactory for the intended applicati
6、on. 6. APPROVAL OF NEW SUPPLERS: 6.1 Pricing of gloves from proposed new suppliers should be determined to be cost competitive by Purchasing and Supply Staff prior to obtaining laboratory and shop trail approvals. After the product has been determined to be cost competitive, gloves submitted by new
7、manufacturers to this standard and concluded to be cost competitive must have laboratory and shop trial approvals. Recommendations for I the addition of new manufacturers to the Hanufacturing Approved Source List (ASL) must be made by the appropriate division FORD MANUFACTURING STANDARDS - SBl-1 JUL
8、Y, 1988 REVERSIBLE TERRY CLOTH GLOVE WITH DUCK GAUNTLET SBl-1 Page 2 standards activity in writing to the Plant Engineering Office. All supporting data must accompany the written request. : 6.2 i The Plant Engineering Office, nanufacturing Staff, and the Environmental Health and Safety Hanager, Employee Relations Staff, will review requests tc determine approval.
