1、FORD KANUPACTUKXNG STANDARDS SBl-2gA 100% KEVLM KNIT OUTER SHEZL WITH MARCH 1992 100% COTTON INNER LINER WITH PVC COATING SB1-28A Page 1 1. USAGE: These gloves are designed for use by employees requireing a greater degree of cut and laceration protection needing a form fit and additional cusioning a
2、gainst impact contacts to the hand. The use of these gloves must be approved by the Safety Unit. 2. MA- The glove body outer shell is to be knit of 1 end of 17/4 and 2 en and reinforcement over thumb and index finger shall be 2 ends of 24/4 Kevlar yarn. 3. SIZE: Sizing shall be as follows: 11-l/2 in
3、ches (292mm) from tip of middle finger to glove base. Width of the palm shall be 4-l/2 inches (114mm) at the thumb crotch. Width of the wrist shall be 4 inches (102mm). Glove shall have 2-l/4 inch (57rmu) flared cuff 5-l/2 inches (14Ossn) wide at the glove base. 4. CONSTRUCTION: Gloves are to be pro
4、duced seamless, reversible style with cinched wist incorporated on a knitting machine. Knited cotton liner is inserted in the Kevlar outer shell and bar-tacked at each finger and thumb and further attached at the glove base with Kevlar overcasting. In 90.0 grams per glove after PVC coating. 6. RECLA
5、IMING: These gloves shall be impervious to proper laundering procedures over a prudent recycling span. It is recommended that these gloves not be patched. 7. MANUFACTURERS RESPONSIBILITY: All materials supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted and shall be satisfactory for the intended application.
