1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 1 2015 04 02 N Status Replaced by WRS-M1H1166-A22 D. Murtonen, NA 2014 02 18 Released M. Dumitrescu, NA Controlled document at www.MATS Copyright 2015, Ford Global Technologies, Inc. Page 1 of 2 FABRIC, AXIS PATTERN, FLAT WOVEN WRS-M1H116
2、6-A1 34% PIR/PCR UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven Jacquard face fabric. The fabric is made with 34% PIR/PCR (Post industrial/post-consumer) recycled yarn. 2. APPLICATION This specification was released originally for material us
3、ed as an interior trim fabric for S-Max and Galaxy as seat inserts. The fabric was approved as backcoated and trilaminated. 3. REQUIREMENTS 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Mater
4、ials (WSS-M99P1111-A). Materials with recycled content as defined by WRS-M99P42-A2 (Textile Materials, Identification of Recycled Content) should be used whenever technically feasible. 3.1.1 This specification must contain 34% recycled content as defined by WRS-M99P42-A2. The remaining portion of th
5、e material can come from virgin sources. 3.1.2 In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 800 ends/10 cm Weft 270 picks/10 cm 3.2.2 Fabr
6、ic Weight, +/-10 % tolerance, (FLTM BN 106-01) Face fabric 300 g/m2 Backcoat 30 g/m2 Total weight 330 g/m2 ENGINEERING MATERIAL SPECIFICATION WRS-M1H1166-A1 Copyright 2015, Ford Global Technologies, Inc. Page 2 of 2 3.3 COMPOSITION (ASTM D 629) Tolerance as specified in WSS-M8P18-A1/A4 Fabric 100% P
7、olyester Backcoating Acrylic Backing scrim Circular knit polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 167 dtex (semi-dull polyester yarn) x 1 Weft 167 dtex (100% recycled semi-dull polyester yarn) x 2 3.5 METHOD OF DYEING Piece dye/Solution dye 3.6 FINISHING OPERATIONS wash, dye, dry, tenter,
8、backcoated, Or as approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications. 4.1 Purchase departments will
9、ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only. 4,2 Global strategy to use Tri-Laminate construction in all regions. 4.3 If yarn is locally sourced it must meet the above fabric construction, composition and Yarn construction. The fabric must also meet the requirements of WSS-M8P18-A1/A2/A3/A4.
