1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions Rev. 2 2010 01 20 N-STATUS Replaced by WSS-M1H1016-B M. Dumitrescu, NA 2009 07 09 Revised Updated 3.6; added 4 & 4.1 M. Dumitrescu, NA 2006 01 09 Activated M. Dumitrescu Printed copies are uncontrolled Copyright 2010, Ford Global Technologies,
2、 LLC Page 1 of 2 FABRIC, SPECK PATTERN, KNIT WSS-M1H1016-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a SPECK PATTERN, 4 bars, 28 Gauge, TRICOT knit, body cloth of good quality and uniform composition. 2. APPLICATION This specification was released originall
3、y for material used as an interior trim fabric for 2007 P356 seat bolster. 3. REQUIREMENTS In addition, to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers
4、 must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 5% tolerance (ASTM D 3887) Wales 126 wales/10 cm Courses 252 courses/10 cm 3.2.2 Fabric Weight, range, g/m2 (FLTM BN 106-01) Laminated * Face w/no Backcoat 4
5、53 - 500 320 - 353 * 3 mm foam thickness 3.3 COMPOSITION (ASTM D 629) Tolerance as specified in WSS-M8P18-A1/A4 Fabric 100% Polyester ENGINEERING MATERIAL SPECIFICATIONWSS-M1H1016-A Printed copies are uncontrolled Copyright 2010, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM
6、D 1244) Face (A) 64% 11.1 tex (textured polyester yarn) (B) 4.5% 11.1 tex (textured polyester yarn) Middle 4.5% 11.1 tex (textured polyester yarn) Back 28% 11.1tex (textured polyester yarn) 3.5 METHOD OF DYEING Piece Dye and/or solution dye 3.6 FINISHING OPERATIONS Washing, heat-setting, resin-finis
7、h, heat setting Note: The fabric is treated with maximum 1% resin to prevent seam appearance issue due to broken filaments. 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase department will ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
