1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 12 16 N-STATUS V. Demarchi, FSAO 2006 06 12 Activated L. Neves Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 1 of 2 FABRIC, MODA PATTERN, WOVEN WSS-M1H1096-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The
2、material defined by this specification is a woven polyester fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for Ranger. 3. REQUIREMENTS Material specification requirements are to be used for initial qualification of materials. In additio
3、n to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements for Production Materials (WSS-M99P1111-A). 3
4、2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 5% (ASTM D 3775) Warp 18.5 yarn/cm Fill 16.5 yarn/cm 3.2.2 Fabric Weight, range (FLTM BN 106-01) laminated to 2.6 mm foam + backing fabric 325 - 352 g/m 3.3 COMPOSITION (ASTM D 629) Fabric 100% Polyester Foam PUR/Polyether Backing Fabric (Seats) 100% Po
5、lyester ENGINEERING MATERIAL SPECIFICATIONWSS-M1H1096-A Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp PES 560 dtex f 144, Semi Dull Air Texturized, Solution Dyed Fill PES 560 dtex f 144, Semi dull Air Texturized, So
6、lution Dyed PES 830 dtex f 240, Semi dull Air Texturized, Yarn Dyed 3.5 FINISHING OPERATIONS Heat Set, Lamination to foam and backing fabric 3.6 THICKNESS, mm, range (ASTM D 1777) Laminated to 2.6 mm foam + backing fabric 2.0 2.4 mm 3.7 TRIMMABILITY PROPERTIES 3.7.1 Stretch, %, +/- 5% (SAE J855) War
7、p 7.0% Fill 2.0% 3.8 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that material defined in this specification and shipped to anyone assembly plant will be produced by one supplier only.
