1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2009 01 06 N-STATUS No Replacement B. Haggart, FNA 2003 03 18 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.18, 3.19, 4 deleted 1996 12 09 Activated N.J. KomatsuPrinted copies are uncontrolled Page 1 of
2、2 Copyright 2009, Ford Global Technologies, Inc. FABRIC, STYLIZE, JACQUARD WOVEN WSS-M1H708-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an
3、 interior trim fabric for the 1998 MY BE146. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Comp
4、anys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 242 ends/10 cm Weft 150 picks/10 cm 3.4.2 Fabric Weight, range 285 - 315 g/m2(FLTM BN 106-01) 3.5 COMPOSITION (ASTM D 629) Fabric 100 % polyester ENG
5、INEERING MATERIAL SPECIFICATION WSS-M1H708-A Page 2 of 2 Copyright 2009, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 760 dtex resultant f144 (polyester, semi- dull, air texturised, round section) Weft 760 dtex resultant f144 (polyester, semi-dull, air texturised, round se
6、ction) 3.7 METHOD OF DYEING Yarn dyed and spun or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
