1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 02 06 N-STATUS No replacement named M. Dumitrescu 2003 04 10 Revised Para 3.0 inserted; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1997 10 30 Activated N.J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies,
2、LLC Page 1 of 2 FABRIC, SWIFT STRETCH PATTERN, WOVEN WSS-M1H757-A JACQUARD, UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an inter
3、ior trim fabric for BE 146. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Req
4、uirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 240 ends/10 cm Weft 150 picks/10 cm 3.4.2 Fabric Weight, range +/- 15% 290 - 320 g/m2(FLTM BN 106-01) 3.5 COMPOSITION (ASTM D 629) Fabric 100% polyester ENGINEERING M
5、ATERIAL SPECIFICATIONWSS-M1H757-A Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 830 dtex f256 (polyester, semi-dull, round, air texturized) 730 dtex f144 (polyester, bright, trilobal, air texturized) Weft 830 dtex f
6、256 (polyester, semi-dull, round, air texturized) 3.7 METHOD OF DYEING Yarn dyed and spun or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used
7、 as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification: 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
