1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2003 02 24 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1998 04 28 Activated N.J. Komatsu Printed copies are u
2、ncontrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, TRELLIS PATTERN, WOVEN JACQUARD, WSS-M1H784-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was
3、released originally for material used as an interior trim fabric for 2000 MY BE91 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and pa
4、rt producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 7 % tolerance (ASTM D 3775) Warp 270 ends/10 cm Weft 142 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 260 - 300 g/m23.5 COMPOSITION (A
5、STM D 629) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H784-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 600 dtex f192 (air texturized)Weft 600 dtex f192 (air texturized)3.7 METHOD OF DYEING Yarn dyed or as approved by Mate
6、rials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
