1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 02 21 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1998 07 21 Activated N.J. KomatPrinted copies are uncon
2、trolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, COLLAGE PATTERN, WOVEN JACQUARD, WSS-M1H795-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was rele
3、ased originally for material used as an interior trim fabric for 1999 model year. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall met all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and par
4、t producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 10 % tolerance (ASTM D375) Warp 240 ends/10 cm Weft 145 picks/10 cm 3.4.2 Fabric Weight 280 - 320 g/m2(FLTM BN 106-01) 3.5 COMPOSITION (ASTM D 629
5、) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H795-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 760 dtex f192 (polyester, round, air texturized, semi-dul)730 dtex f144 (polyester, trilobal, air texturized, bright) Weft 760
6、dtex f192 (polyester, round, air texturized, semi-dul)3.7 METHOD OF DYEING Yarn dyed and spun or as aprovebyMaterials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used
7、 as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
