1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 17 N-STATUS No Replacement B. Haggart, FNA 2003 02 24 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1999 02 26 Activated Lara Daniv-Zarewych Printed copies are uncontrolled Pa
2、ge 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, HOPSACK PATTERN, WOVEN WSS-M1H803-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a Dobby Rapier pattern flat woven body cloth of good quality and uniform composition. 2. APPLICATION This specific
3、ation was released originally for material used as an interior trim fabric for 2001 Ranger Bolster. The fabric used is backcoated and laminated. 3. REQUIREMENTS In addition, to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A4 as applicable. The fabric must be
4、 backcoated. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 190 warp/10 cm Fill 170
5、 fill/10 cm 3.4.2 Fabric Weight, range, g/m2(FLTM BN 106-01) Laminated * Face with Backcoat 425 - 495 326 - 395 * At 3 mm thickness ENGINEERING MATERIAL SPECIFICATION WSS-M1H803-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.5 COMPOSITION (ASTM D 629) Tolerance as specified in WSS-M8
6、P18-A1/A4 Fabric 100 % Polyester Backcoating 100 % Polyester 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 80.6 tex, f192, 1 ply, (natural polyester) Fill 80.6 tex, f192, 1 ply, (natural polyester) 3.7 METHOD OF DYEING Piece, Solution 3.8 FINISHING OPERATIONS Dye, Dry, Backcoat 3.9 FLAMMABILITY (ISO 3795
7、/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
