1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 04 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 03 21 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 2000 07 31 Activated N. J. Komatsu Printed copies are u
2、ncontrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, KARINE, FLAT, WOVEN, UNLAMINATED WSS-M1H839-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a flat woven polyester face fabric. 2. APPLICATION This specification was released origina
3、lly for material used for adhesive bonded door and quarter trim panel applications 2001 Model Year. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Materia
4、l suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 272 ends/10 cm Weft 197 picks/10 cm 3.4.2 Fabric Weight, range 285 - 315 g/m2(FLTM BN 106-01)
5、3.5 COMPOSITION (ASTM D 629) Fabric 100 % polyester 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 520 dtex f96 (round, air texturized, semi-dul) Weft 730 dtex f144 (bright, trilobal air texturized) ENGINEERING MATERIAL SPECIFICATION WSS-M1H839-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc.
6、3.7 METHOD OF DYEING Yarn dyed and spun or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification: 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
