1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 12 05 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2004 07 12 Activated N. J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 1 of 2 FABRIC, ELEMENT PATTERN, WOVEN JACQUARD, WSS-M
2、1H888-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for 2003 Model Year. 3. REQUIREMENTS In addition to
3、the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FA
4、BRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 5% tolerance (ASTM D 3775) Warp 250 ends/10 cm Weft 160 picks/10 cm 3.2.2 Fabric Weight, range 223 +/- 22 g/m2(FLTM BN 106-01) 3.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 400 dtex f136 (polyester air jet textur
5、ized, round, semi-dull) Weft 650 dtex f144 (polyester semi- dull, round, air jet texturized) ENGINEERING MATERIAL SPECIFICATIONWSS-M1H888-A Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.5 METHOD OF DYEING Package dyed or as approved by Materials Engineer
6、ing 3.6 FINISHING OPERATIONS As approved by Materials Engineering 3.7 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
