1、ABN 84 006 893 232 GM Holden Limited Engineering Department MATERIAL SPECIFICATION NUMBER SHEET RELEASE REVISION : HN 2484 1 of 2 September, 2006 NAME: PANEL BONDING ADHESIVE THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRM TH
2、E DOCUMENT ISSUE DATE IS STILL VALID. FORM : I:CentralLaboratoryStandardForms MaterialSpecificationMatspec.doc 1. SCOPE This specification covers the performance requirements for a two-part toughened epoxy adhesive system suitable for bonding steel, aluminium and plastic surfaces. These types of adh
3、esives are intended to be used to bond and seal replacement body panels. The material should comply with the full technical requirements of GM6449G of which some are shown below. 2. REFERENCES GM6449G ASTMD1002 HN 1000 GMW3059 3. PROPERTIES 3.1 Consistency Viscous Paste 3.2 Pot Life (23 oC) 60 minut
4、es 3.3 Working Time (23 oC) 90 minutes 3.4 Handling time (23 oC) 4 hours 3.5 Cure Time (23 oC) Cure time may be accelerated with heat 24 hours Lap Shear (ASTMD1002), Cohesive Failure 3.6.1 Cold Rolled Steel 13 MPa min 3.6.2 Galvanized Steel 13 MPa min 3.6 3.6.3 Aluminium 13 MPa min ABN 84 006 893 23
5、2 GM Holden Limited Engineering Department MATERIAL SPECIFICATION NUMBER SHEET RELEASE REVISION : HN 2484 2 of 2 September, 2006 NAME: PANEL BONDING ADHESIVE THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRM THE DOCUMENT ISSUE
6、DATE IS STILL VALID. FORM : I:CentralLaboratoryStandardForms MaterialSpecificationMatspec.doc 4. COMPATIBILITY The material must be compatible with GM Holden ELPO and Paint system. 5. APPROVAL, INSPECTION AND REJECTION Refer HN 1000, Clauses A and C. 6. HAZARDOUS MATERIALS Refer HN 1000, Clause H 7.
7、 RESTRICTED AND REPORTABLE SUBSTANCES (i) All substances and parts must meet the compositional requirements of GMW3059. (ii) All chemical components present in materials supplied to this specification must comply with Australian NICNAS (National Industrial Chemicals Notification and Assessment Scheme) obligations. 8. APPROVED SUPPLIERS AND MATERIALS Material known to meet the full requirements of this specification: APPROVED SUPPLIER APPROVED MATERIAL 3M Automix 8115 Prepared by: Y. Zia
