INTA 14 05 56 《平行剪切（木）》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

AASHTO HB-17 DIVISION I SEC 5-2002 Division I Design - Retaining Walls ((Part A Part B and Part C) Errata 01 2003)《抗振设计-抗震性能范围C的桥梁设计要求》.pdf

AASHTO HB-17 DIVISION I SEC 6-2002 Division I Design - Culverts《涵洞》.pdf

AASHTO HB-17 DIVISION I SEC 7-2002 Division I Design - Substructures ((Part A Part B and Part C))《底部构造》.pdf

AASHTO HB-17 DIVISION I SEC 8-2002 Division I Design - Reinforced Concrete ((Part A Part B Part C and Part D))《钢筋混凝土》.pdf

AASHTO HB-17 DIVISION I SEC 9-2002 Division I Design - Prestressed Concrete ((Part A Part B Part C and Part D))《预应力混凝土》.pdf

AASHTO HB-17 DIVISION I-2002 Design《设计》.pdf

AASHTO HB-17 DIVISION I-A SEC 1-2002 Division I-A Seismic Design - Introduction《抗振设计-前言》.pdf

AASHTO HB-17 DIVISION I-A SEC 2-2002 Division I-A Seismic Design - Symbols and Definitions《抗振设计-符号和定义》.pdf

AASHTO HB-17 DIVISION I-A SEC 3-2002 Division I-A Seismic Design - General Requirements《抗振设计-一般要求》.pdf