INTA 83 22 01 《飞机轮架的车内胎》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

EN 12811-4-2013 en Temporary works equipment - Part 4 Protection fans for scaffolds - Performance requirements and product design《临时工作设备 第4部分 脚手架保护风机 性能要求和产品设计》.pdf

EN 12812-2008 en Falsework - Performance requirements and general design《脚手架 性能要求和一般设计》.pdf

EN 12813-2004 en Temporary works equipment - Load bearing towers of prefabricated components - Particular methods of structural design《临时工程设备 预制构件的承重塔 结构设计的特殊方法》.pdf

EN 12814-1-1999 en Testing of welded joints of thermoplastics semi-finished products - Part 1 Blend test (Incorporating Corrigendum September 2003)《热塑性半成品的焊接接头试验 第1部分 弯曲试验 合并勘误表-20.pdf

EN 12814-2-2000 en Testing of Welded Joints of Thermoplastics Semi-Finished Products - Part 2 Tensile Test《热塑性塑料半成品的焊接接头试验 第2部分 拉伸试验》.pdf

EN 12814-3-2014 en Testing of welded joints in thermoplastics semi-finished products - Part 3 Tensile creep test《热塑半成品焊缝试验 第3部分 焊接接头拉伸蠕变试验》.pdf

EN 12814-4-2001 en Testing of Welded Joints of Thermoplastics Semi-Finished Products - Part 4 Peel Test《热塑性半成品的焊接接头试验 第4部分 剥落试验》.pdf

EN 12814-5-2000 en Testing of Welded Joints of Thermoplastics Semi-Finished Products - Part 5 Macroscopic Examination《热塑性半成品的焊接接头试验 第5部分 宏观检验》.pdf

EN 12814-6-2000 en Testing of Welded Joints of Thermoplastics Semi-Finished Products - Part 6 Low Temperature Tensile Test《热塑性塑料半成品的焊接接头试验 第6部分 低温拉伸试验》.pdf