1、 This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2009 by Navistar, Inc. AUGUST 2009 Page 1 of 1 NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPECI
2、FICATION) NUMBER: CEMS BT-18 TITLE: Ash Of Ramsbottom Carbon Residue Test CURRENT ISSUE DATE: August 2009 WRITTEN/REVIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: October 2001 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION This specifi
3、cation may involve hazardous materials, equipment, and procedures. This specification does not purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of regulatory limits prior
4、 to use. Change Notice: Replaced “International Truck and Engine Corporation” with “Navistar, Inc.” per corporate directive. 1.0 SCOPE This method covers a test procedure for determination of the Ash of Ramsbottom Carbon Residue. 2.0 APPARATUS 2.1 Ramsbottom Carbon Residue appartus per ASTM D 524. 2
5、2 Coors No. 1 porcelain crucible. 2.3 Muffle furnace capable of maintaining 1200 + 20F (650 + 10C). 2.4 Ashless filter circles, 15 centimeter. 2.5 Hammer or other heavy metal object. 3.0 PROCEDURE 3.1 Prepare coking bulb in accordance with ASTM D 524, section 5 (a), Test for Ramsbottom Carbon Resid
6、ue. 3.2 Place bulb in a preignited, Coors No. 1 porcelain crucible and weigh to the nearest 0.1 milligram. 3.3 Treat bulb in accordance with ASTM D524, Section 5 or 6. 3.4 Calculate carbon residue in accordance with ASTM D 524, section 7. 3.5 Wrap bulb and residue in an ashless 15 centimeter filter
7、circle, and break with the edge of a hammer or other heavy metal object, being careful not to lose any particles of glass or residue. 3.6 Place the wrapped broken bulb in the crucible. Ignite in a muffle furnace at 1200 + 20F(650 +10C) for one hour or until all carbonaceous residue is burned off. 3.
8、7 Cool and reweigh to the nearest 0.1 milligram. 4.0 REPORT Calculate the Ash of Ramsbottom Carbon Residue as follows: D-C 100W =Ash of Carbon Residue where: D = weight of bulb, crucible and ash of carbon residue C = Weight of empty bulb and crucible W = weight of sample used Report the values obtained as “Ash of Ramsbottom Carbon Residue, percent” or as “Ash of Ramsbottom Carbon Residue on 10 percent residuum, percent”. Copyright Navistar International Corporation Provided by IHS under license with INTERNNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
