IS 2630-1992 Nitrobenzene Specification (Second Revision).pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 24961-1981 Plate double-end plug gauges with diameter from 14 to 98 mm Design and dimensions《直径 14mm～98mm双头板塞规 结构及尺寸》.pdf

GOST 24962-1981 Go plug gauges of not full form with diameter from 102 to 125 mm Design and dimensions《直径 102mm～125mm不完整通端塞规 结构及尺寸》.pdf

GOST 24963-1981 Not-go plug gauges of not full form with diameter from 102 to 125 mm Design and dimensions《直径 102mm～125mm不完整止端塞规 结构及尺寸》.pdf

GOST 24964-1981 Not-go snap-gauges for checking internal diameter of splined shafts with straight-sided profile when centering by D or b Design and dimensions《直齿花键轴按D或b定心时内径检验用止端卡规.pdf

GOST 24965-1981 Double-end snap-gauges for checking internal diameter of splined shafts with straight-sided profile when centering by d Design and dimensions《直齿花键轴按d定心时内径检验用双面卡规 结构.pdf

GOST 24966-1981 Double-end snap-gauges for checking tooth thickness of splined shafts with straight-sided profile Design and dimensions《直齿花键轴齿厚度检验用双头卡规 结构及尺寸》.pdf

GOST 24967-1981 Splined gauges for dimensions up to 3 mm Design and dimensions《尺寸 3mm槽量规 结构及尺寸》.pdf

GOST 24968-1981 Splined gauges for dimensions over 3 to 18 mm Design and dimensions《尺寸 3mm槽量规 结构及尺寸》.pdf

GOST 24969-1981 Gauges for checking 30 involute splined joints Tolerances《齿形30角花键连接检验用量规 公差》.pdf