JRIS R 0219-1-2016 Rolling stock - Side windows - Part 1 Structures of side windows.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 6912-2009 Hexagon socket head cap screws with centre with low head《六角中心低圆柱头插座帽螺钉》.pdf

DIN 6917-1989 Square taper washers for high-strength structural bolting of steel I sections《“工”字形钢型材高强度螺栓连接用的方锥形垫圈》.pdf

DIN 6918-1990 Square taper washers for high-strength structual bolting of steel channel sections《钢结构U型梁高强度螺栓连接用四角楔形垫圈》.pdf

DIN 6929-2013 Screws with coarse thread and reduced shank for captive applications《粗牙螺纹螺丝和捕获用细杆》.pdf

DIN 6930-1-2011 Stamped steel parts - Part 1 Technical delivery conditions《冲压钢构件 第1部分 技术交货条件》.pdf

DIN 6930-2-2011 Stamped steel parts - Part 2 General tolerances《冲压钢构件 第2部分 通用公差》.pdf

DIN 6932-2011 Design rules for stamped steel parts《冲压钢构件的设计规范》.pdf

DIN 6935 Bb 1-2011 Cold bending of flat rolled steel - Supplement 1 Factors determining the correction value for calculating length of flats prior to bending《平轧钢冷弯加工 补充件1 决定扁钢冷弯加工前.pdf

DIN 6935 Bb 2-2011 Cold bending of flat steel products - Supplement 2 Calculated compensating values 《冷弯钢或扁钢产品 补充件2 计算的补偿值》.pdf