JUS C A1 168-1982 Methods for chemical analya-s of copper and copper alloys Gravimetric determination of zine in copper alloys《铜和铜合金的化学分析方法 重量法测定铜合金中的锌量》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 3966-2-1978 Information on Gear Teeth in Drawings Information on Straight Bevel Gear Teeth《图纸上齿轮啮合信息 第2部分 直齿伞齿轮啮合信息》.pdf

DIN 3967-1978 System of Gear Fits Backlash Tooth Thickness Allowances Tooth Thickness Tolerances Principles《齿轮配合体系 侧隙、齿厚容差和齿厚公差 原则》.pdf

DIN 3968-1960 Tolerances for Single-start Hobs for Involute Spur Gears《渐开线正齿轮用单头滚铣刀的公差》.pdf

DIN 3969-1-1991 Surface roughness of tooth flanks roughness parameters surface grades《齿面表面粗糙度 粗糙度参数 表面等级》.pdf

DIN 3970-2010 Master gears for checking cylindrical gears - Gear blanks and gearing《圆柱齿轮检查用标准齿轮 齿轮毛坯和齿轮传动》.pdf

DIN 3971-1980 Definitions and Parameters for Bevel Gears and Bevel Gear Pairs《伞齿轮和伞齿轮副的定义和参数》.pdf

DIN 3972-1952 Reference Profiles of Gear-cutting Tools for Involute Tooth Systems according to DIN 867《与DIN 867相符的渐开线齿轮装置的齿轮切削刀具的基准齿廓》.pdf

DIN 3973-1-2017 Tolerances of worm wheel hobs - Part 1 Fundamental principles《蜗轮滚刀公差 第1部分 基本原则》.pdf

DIN 3973-2-2017 Tolerances of worm wheel hobs - Part 2 Tolerances for deviation of individual parameters.pdf