JUS H C8 205-1989 Pigments and extenders Determinati on of oil absorption value《颜料和填充剂 油吸值测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 28046-1989 Internal broaches for straight splines based at internal diameter three pass combined type Construction《内径定心直齿十键孔用三次拉削成型的交替切削装配式组合拉刀 结构》.pdf

GOST 28047-1989 Internal broaches for straight splines based at internal diameter four pass combined type Construction《内径定心直齿十键孔用四次拉削成形的交替切削装配式组合拉刀 结构》.pdf

GOST 28048-1989 Broaches with diameter from 50 to 120 mm for slitting holes with involute profile with round tail and centring at outside diameter with modul frome 1 5 to 2 5 mm Co.pdf

GOST 28049-1989 Broaches with diameter from 90 to 120 mm for slitting holes with involute profile with round tail and centring at outside diameter with modul from 2 5 mm Constructi.pdf

GOST 28050-1989 Broaches with diameter from 55 to 130 mm for slitting holes with involute profile with round tail and centring at outside diameter with modul from 3 to 5 mm Constru.pdf

GOST 28051-1989 Broaches with diameter from 70 to 130 mm for slitting holes with involute profile with round tail and centring at outside diameter with modul from 3 to 5 mm Constru.pdf

GOST 28052-1997 Titanium and titanium alloys Methods of oxygen determination《钛和钛合金 氧含量测定法》.pdf

GOST 28053-1989 Chips of non-ferrous metals and alloys Methods of sampling sample preparation and test methods《有色金属及合金的刨削 取样、样品制备的方法及试验方法》.pdf

GOST 28054-1989 Interface of fourlead keyboard General requirements《四线数据输入键盘接口》.pdf