JUS H G8 010-1980 Reagents Hydrochloric acid Determination oj appearance《试剂 盐酸 外观测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS EN ISO 7250-1-2017 Basic human body measurements for technological design Body measurement definitions and landmarks《工艺设计用基本人体测量 人体测量定义和标志》.pdf

BS EN ISO 7263-2011 Corrugating medium Determination of the flat crush resistance after laboratory fluting《瓦楞芯纸 实验室起瓦楞后耐平压性的测定》.pdf

BS EN ISO 7278-1-1990 Liquid hydrocarbons - Dynamic measurement - Proving systems for volumetric meters - General principles《液态烃 动态测量 容积计量计正系统 第1部分 一般原理》.pdf

BS EN ISO 7278-2-1990 Liquid hydrocarbons - Dynamic measurement - Proving systems for volumetric meters - Pipe provers《液态烃 动态测量 容量计的验证系统 第2部分 管式校准仪》.pdf

BS EN ISO 7287-2002 Graphical symbols for thermal cutting equipment《热切割设备用图形符号》.pdf

BS EN ISO 7291-2010 Gas welding equipment Pressure regulators for manifold systems used in welding cutting and allied processes up to 30 MPa (300 bar)《气焊设备 30 MPa(300 bar)以下的焊接 切削及.pdf

BS EN ISO 7326-2016 Rubber and plastics hoses Assessment of ozone resistance under static conditions《橡胶和塑料软管 静态条件下评定耐臭氧性》.pdf

BS EN ISO 7327-1996 Plastics - Hardeners and accelerators for epoxide resins - Determination of free acid in acid anhydride《塑料 环氧树脂用固化剂和促进剂 酸酐中游离酸测定》.pdf

BS EN ISO 7328-2008 Milk-based edible ices and ice mixes - Determination of fat content - Gravimetric method (Reference method)《奶基可食用冰淇淋和冰淇淋混合物 脂肪含量的测定 重量分析方法(参考方法)》.pdf