JUS N K5 014-1987 Low-voltage controlgear Contactors Protection of a contactorby a short-circuit protective device《低压控制开关 接触器 带短路保护装置的接触器》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

HB 2440-1979 加工模具用锥柄三齿锥形立铣刀.pdf

HB 2441-1979 加工模具用直柄半圆头三齿锥形立铣刀.pdf

HB 2442-1979 加工模具用锥柄半圆头两齿锥形立铣刀.pdf

HB 2443-1979 加工模具用锥柄半圆头三齿锥形立铣刀.pdf

HB 2444-1979 铣柄式铣刀齿槽用槽铣刀 D=18~80mm.pdf

HB 2445-1979 样板及对样板检验 HB2444-79 槽铣刀用.pdf

HB 2446-1979 铣套式铣刀齿槽用槽铣刀 D=63~80mm.pdf

HB 2447-1979 样版及校对样板检验HB2446-79 槽铣刀用.pdf

HB 2448-1979 铣镶片铣刀5'。槽用槽铣刀 D=100~125mm.pdf