MSZ 56-1982 《地板，墙壁》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 3586-2003 Thermally activated shutting-off devices for gas - Requirements and testing《燃气设施用热驱动关闭设备 要求和试验》.pdf

DIN 3606-1954 Pipe hoisting caps for casing pipes according to DIN 4918《按DIN 4918钻管用的管子提升滑块》.pdf

DIN 37080-1975 Adjusting Equipment for Brake Blocks Survey and Arrangement《制动器闸瓦的调节装置 概述和配置》.pdf

DIN 37081-1982 Adjusting equipment for brake blocks Brackets Spring plates《制动闸瓦的调节装置 支座、离合器弹性被动片》.pdf

DIN 37082-1975 Adjusting Equipment for Brake Blocks Compression Springs Spring Bolt《制动踢片的调节装置 弹簧螺栓的压力弹簧 》.pdf

DIN 371-2016 Machine taps with reinforced shank for coarse pitch metric ISO-threads M1 to M10 and fine pitch metric ISO-threads M1 × 0 2 to M10 × 1 25《米制粗螺距ISO螺纹M1至M10和米制细螺距ISO螺纹M1.pdf

DIN 373-2007 Counterbores with parallel shank and solid pilot《带直柄和固定导杆的埋头钻》.pdf

DIN 374-2016 Machine screwing taps for fine pitch metric ISO-threads M3 × 0 2 to M52 × 4《米制细螺距ISO螺纹M3×0 2至M52×4机器丝锥》.pdf

DIN 375-2007 Counterbores with Morse taper shank and detachable pilot《带莫氏锥柄和可拆卸导柱的埋头钻》.pdf