1、This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2010 by Navistar, Inc. Revision: 4 Page 1 of 22 Truck Design Standard NUMBER: TDS-SD-10 TITLE: Dimensioni
2、ng and Tolerancing Addendum REVISION: 4 WRITTEN / REVIEWED BY: Dewayne Dimit APPROVED BY: Truck Design Standards Team DATE ISSUED: July 2010 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION NOTE: This document is required to be revised or reviewed a within a minimum time period
3、as defined in QMS-PR-002. INTERNATIONAL TRUCK DIVISION DIMENSIONING AND TOLERANCING ADDENDUM-2000 INDEX Introduction- A Acknowledgments- B SECTION 1 Scope, Definitions, and General Dimensioning General- 1.1 Definitions- 1.2 Default GD Remove items 4.), 5.), and 6.) under the “UNLESS OTHERWISE SPECIF
4、IED” heading. (This will also affect Stamp #47.) 2. Page 14, Para. 7.1.3; 7.4.7 should read 7.3.7. Sections 7 and 8 show the X,Y,Z coordinates on certain drawings of sheet metal parts. Most (if not all) new Body Group sheet metal parts do not show the coordinates on the drawing because they exist in
5、 the math data. They should not be shown in the addendum; but we must get Body Group management approval to remove or revise that information. 3. Page 20, Para. 8.3; Remove the phrase; “on all body drawings and in the 3-D math model.” 4. Figure 7-1 and Figure 8-1; Remove all of the X,Y,Z coordinate callouts from the face of the drawings. ?“ Truck Design Standards Team Jul 2010
