1、 This document is restricted and may not be sent outside International Truck and Engine Corporation or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. Ge32001 International Truck and Engine Corporation For Further information C
2、ontact: Materials Engineering Truck Development and Technology Center 2911 Meyer Rd., Post Office Box 1109, Ft. Wayne, Indiana 46801-1109 Email: MaterialsEngineeringNav-I. AUGUST 2001 Page 1 of 1 INTERNATIONAL TRUCK AND ENGINE CORPORATION TMS (TRUCK MATERIAL SPECIFICATION) NUMBER: TMS-9508 TITLE: Sh
3、ot-Peening REVISION: C-1 WRITTEN/EDITED BY: Materials Engineering APPROVED BY: Materials Engineering DATE VOIDED: April 1987 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION This specification may involve hazardous materials, equipment, and procedures. This specification does no
4、t purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of regulatory limits prior to use. Change Notice: VOID Reference: File 40-8 Keywords: Shot-Peening This TMS specificati
5、on has been voided and replaced by CEMS A-39. The following chart is to be used as a cross reference between the original TMS and the current CEMS A-39. TMS-9508 A-39* Clas I Clas 6CH, Coverage 30% min Class II Class 16A, Coverage 200% min Class III Class IND, 10-20A Class IV Class IND, 6-14C *Preferred use for all future engineering drawings. V O I D
