1、DOD-C-24594(SH) AMENDMENT 1 1 September 1982 MILITARY SPECIFICATION CELL, STORAGE, SILVER-ZINC ALKALINE TYPE (FOR DEEP SUBMERGENCE APPLICATIONS) (METRIC) This amendment forms a part of Military Specification DOD-C-24594(SH), dated 6 September 1979, and is approved for use by the Naval Sea Systems Co
2、mmand, Department of the Navy and is avail- able for use by all Departments and Agencies of the Department of Defense. PAGE 1 2.1, under WSPECIFICATIONS, FEDERALVI: Delete reference to 11QQ-B-6131f, “QQ-B-62611, lVQQ-B-6371V , 11QQ-B-639fl , and 1fQQ-C-576n. Beneficial comments statement at bottom o
3、f page, line 3: Delete “SEA 31 121 and substitute ItSEA 5523“. PAGE 2 2.2: Add the following: WAMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) B 21 - Naval Brass Rod, Bar and Shapes (DOD Adopted) B 1 1 - Leaded Brass Plate, Sheet, Strip, and Rolled Bar. B 152 - Copper Sheet, Strip, Plate and Rolle
4、d Bar. (DOD Adopted) - Brass Plate, Sheet, Strip, and Rolled Bar. (DOD Adopted) (DOD Adopted) Lsr (Application for copies should be addressed to the American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA lg103.)11 PAGE 3 3.4.5.1, line 4: Delete tVO.O!j“ and substitute 110.076
5、1f. 3.4.5.3, line 2: Delete n3.3511 and substitute 113.461f. US. GOVERNMENT PRINTING OFFICE 1982-505-022/4418 1 of 5 FSC 6140 THIS DOCUMENT CONTAINS - the test speci- fied in 4.5.3.2.1* each cell shall be cycled at O C + 3 C as recommended in the service manual and as follows: - (a) Cycle 1. Each ce
6、ll shall be charged as recommended in the service manual. Each cell shall then be discharged at 240 A to the corresponding minimum cell voltage. then be discharged at 150 A to the corresponding minimum cell voltage. recommended cut-off voltage then immediately discharged at 200 A for 2 hours. (b) -
7、Cycle 2. Each cell shall be recharged. The cell shall (c) Cycle 3. Each cell shall then be recharged at 100 A to the Data on voltage, current, and electrolyte temperature shall be monitored and recorded. The results of the capacity discharge tests at each rate shall be averaged and the estimated sta
8、ndard deviation calculated according to the following formula: * 1/2 n-1 I 1 Where: s = Estimated standard deviation. n = Number of sample cells. x = Average of results of test. x = Result of individual sample cell. - i Capacity and voltage of each cell shall meet the requirements of 3.3.1 and the a
9、verage percent of rated capacity for all cells shall be equal to or greater than 100 percent of rated capacity plus 3.1 s.“ PAGE 11 6.2.l(g): Delete ltrepair parts“ and substitute llinstallation and checkout parts!. PAGE 16 Figure 2: Delete and substitute the attached figure 2. 3 Provided by IHSNot
10、for ResaleNo reproduction or networking permitted without license from IHS-,-,-I DOD-C-Zq574 (1) 61 W 7777706 0087817 4 9 DOD-C-24594(SH) AMENDMENT 1 LAST PAGE DD Form 1426, Standardization Document Improvement Proposal: Delete address and substitute: “COMMANDER NAVAL SEA SYSTEMS COMMAND (SEA 5523)
11、DEPARTMENT OF THE NAVY WASHINGTON, DC 20362“ Preparing activity: Navy - SH (Project 6140-N574) 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-DOD-C-Zg594 (1) bL 9997906 OO7L 6 m DOD-C-24594(SH) AMENDMENT 1 f- -% I- 6.35 1.250-7 UNC-2A I- l 2 9.39
12、YL 5.33 ALL AROUND t 3.0 TYP sil 11439 NOTE: 1. All dimensions in millimeters are nominal. Threaded hardware 2. designation is unified thread standagd. hours. - Stress relieve (anneal) in air at 165 C + 3OC for at least 4 FIGURE 2. Cell cover. 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
