1、MIL-A-60682 (1) 13 M 7797706 0340856 T m - . MILITARY SPECIFICATION ACTUATOR, ROTARY 1000-37 REMANUFACTURED METAL PARTS ASSEMBLY kea -lo MIL-A-60682(OS) AMENDMENT 1 15 JULY 1986 This amendment forms a part of Military Specification MIL-A-60682(MU), dated 25 April 1967, and is approved for use within
2、 the Naval Sea Systems Command, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 2.1 Delete “MIL-STD-639 Surface Roughness Values Preferred for Army Ordnance Material “ PAGE 2 Add: “2.2 Other publications, The following document fo
3、rms a part of this specification to the extent specified herein. Unless otherwise specified, the issues of the document which are DOD adopted shall be those listed in the issue of the DODISS specified in the solicitation. specified, the issues of documents not listed in the DODISS shall be the issue
4、 of the nongovernment documents which is current on the date of the solicitation. Unless otherwise Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Commanding Officer, Naval Ordnance Station, Sta
5、ndardization Branch (5241), Indian Head, MD 20640-5000, by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of the specification or by letter, i THIS DOCUMENT CONTAINS 4 PAGES. . Provided by IHSNot for ResaleNo reproduction or networking perm
6、itted without license from IHS-,-,-1 MIL-A-bob82 (1) 13 = 73777Ob 0340857 L W MIL-A-60682( OS) AMENDMENT 1 15 JULY 1986 i ANSI 846.1-78 (Application for copies should be addressed to the American National (Nongovernment standards and other pub1 ications are normally available Surface Texture (Surfac
7、e Roughness, Waviness and Lay) Standards Insti tute (ANSI), 1430 Broadway, NY 10018. ) from the organization which prepares or which distributes the documents. These documents also may be available in or through libraries or other informational services. )I1 PAGE 3 4.2.2, line 1, delete “The Ordnanc
8、e Standard Finish Blocks prescribed in MIL-STD-639 . . .I1 and substitute “The roughness comparison standards prescribed in ANSI 46.1-78 . . . . II 1 Preparing Activity: Navy - OS Project No. 1377-N821 2 -i Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
