NAVY MIL-G-85536 (1)-1987 GUN SYSTEM 25-MM AIRCRAFT A A49E-10《 A A49E-1025-MM飞机火炮系统》.pdf

上传人:livefirmly316 文档编号:979414 上传时间:2019-03-13 格式:PDF 页数:2 大小:63.24KB
下载 相关 举报
NAVY MIL-G-85536 (1)-1987 GUN SYSTEM 25-MM AIRCRAFT A A49E-10《 A A49E-1025-MM飞机火炮系统》.pdf_第1页
第1页 / 共2页
NAVY MIL-G-85536 (1)-1987 GUN SYSTEM 25-MM AIRCRAFT A A49E-10《 A A49E-1025-MM飞机火炮系统》.pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

1、MIL-G-85536(AS) AMENDMENT 1 24 March i987 MILITARY SPECIFICATION GUN SYSTEM, 25-Mb1, AIRCRAFT A/A49E-10 This amendment forms a part of Military Specification MIL-G-85536(AS) dated 24 May 1984, and is approved for use by the Naval Air Systems Command, Department of the Navy, and is available for use

2、by all Departments and agencies of the Department of Defense. PAGE 2 . Paragraph 2.1.2, delete “1395AS104 Drive Unit, Pneumatic“ and substitute “1395AS1016 Drive Unit, Pneumatic“; and add “1395AS109 Drive Assembly Gun“ and 1395AS156 Shaft, Splined Crossover.“ PAGE 3 Paragraph 2.2, under the title, M

3、cDonnell Aircraft Company, add “758732803 Assembly-Nose Fairing, 25-mm Gun Pak.“ PAGE 4 Table I, delete “Pneumatic Drive Unit 1395AS104 and substitute “Pneumatic Drive Unit 1395AS1016.“ PAGE 6 Paragraph 3.2.1.6.2, line 2:delete “The limits specified in Figure 1“ and substitute “675 in-lbs.“ DISTRIBU

4、TION STATEMENT A. Approved for public release: distribution is unlimited. AMSC N/A Page 1 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-G-85536 (AS) AMENDMENT 1 f PAGE 7 Figure 1: delete PAGE 10 Paragraph 4.2, line 2, add ?Table III tests

5、may be performed without the Gun Pak Nose Fairing (Ref. P/N 75A732803) attached to the Gun Pak (Ref. P/N 75A732506). The Gun Drive Assembly (P/N 1395AS109) and Crossover Shaft (P/N 1395AS156)-may be substituted in Table III tests for data acquisition.? PAGE 11 Paragraph 4.2.3, line 6,delete 360F and

6、 substitute 16OoF, and following line 8 add ?If acceleration and firing rates are recorded below the limits of 3.2.1.2 then retest at 4OOOF. Minimum inlet air is required. PAGE 12 Paragraph 4.2.4, line 3)add ?If visual examination of the ammunition handling subsystem, 25m, Aircraft. CFK-11/49E-10 (1

7、395AS102) result in detection of up to and including five missing external retaining rings (MS16632-4025) from the linear linkless ammunition conveyor assemblies, they shall be replaced without retesting.? 1 Preparing Activity Navy-AS (Proj ect 1005-705 1 Page 2 of 2 o Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • EN 1440-2008 5625 LPG equipment and accessories - Periodic inspection of transportable refillable LPG cylinders (Incorporates Amendment A1 2012)《液化石油气(LPG)设备和附件 可运输可再填装LPG气瓶的周期检查[代.pdf EN 1440-2008 5625 LPG equipment and accessories - Periodic inspection of transportable refillable LPG cylinders (Incorporates Amendment A1 2012)《液化石油气(LPG)设备和附件 可运输可再填装LPG气瓶的周期检查[代.pdf
  • EN 1440-2016 en LPG equipment and accessories - Transportable refillable traditional welded and brazed steel Liquefied Petroleum Gas (LPG) cylinders - Periodic inspection (Incorpor.pdf EN 1440-2016 en LPG equipment and accessories - Transportable refillable traditional welded and brazed steel Liquefied Petroleum Gas (LPG) cylinders - Periodic inspection (Incorpor.pdf
  • EN 1442-2006 en LPG equipment and accessories - Transportable refillable welded steel cylinders for LPG - Design and construction (Incorporates Amendment A1 2008)《液化石油气(LPG)设备和附件 L.pdf EN 1442-2006 en LPG equipment and accessories - Transportable refillable welded steel cylinders for LPG - Design and construction (Incorporates Amendment A1 2008)《液化石油气(LPG)设备和附件 L.pdf
  • EN 1442-2017 en LPG equipment and accessories - Transportable refillable welded steel cylinders for LPG - Design and construction.pdf EN 1442-2017 en LPG equipment and accessories - Transportable refillable welded steel cylinders for LPG - Design and construction.pdf
  • EN 1443-2003 en Chimneys - General Requirements《烟囱 一般要求》.pdf EN 1443-2003 en Chimneys - General Requirements《烟囱 一般要求》.pdf
  • EN 1444-2000 en Fibre-Cement Pipelines - Guide for Laying and On-Site Work Practices《纤维水泥管道 现场工作实践和铺设指南》.pdf EN 1444-2000 en Fibre-Cement Pipelines - Guide for Laying and On-Site Work Practices《纤维水泥管道 现场工作实践和铺设指南》.pdf
  • EN 1447-2009 en Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Determination of long-term resistance to internal pressure (Incorporates Amendment A.pdf EN 1447-2009 en Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Determination of long-term resistance to internal pressure (Incorporates Amendment A.pdf
  • EN 145-1997 en Respiratory Protective Devices - Self-Contained Closed-Circuit Breathing Apparatus Compressed Oxygen or Compressed Oxygen-Nitrogen Type - Requirements Testing Markin.pdf EN 145-1997 en Respiratory Protective Devices - Self-Contained Closed-Circuit Breathing Apparatus Compressed Oxygen or Compressed Oxygen-Nitrogen Type - Requirements Testing Markin.pdf
  • EN 1451-1-1998 en Plastics Piping Systems for Soil and Waste Discharge (Low and High Temperature) within the Building Structure - Polypropylene (PP) - Part 1 Specifications for Pip.pdf EN 1451-1-1998 en Plastics Piping Systems for Soil and Waste Discharge (Low and High Temperature) within the Building Structure - Polypropylene (PP) - Part 1 Specifications for Pip.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1